Sun Fire V445 Server Administration Guide - SCN Research

Stop-A Function
Stop-A (Abort) key sequence works the same as it does on systems with standard
keyboards, except that it does not work during the first few seconds after the server
is reset. In addition, you can issue the ALOM system controller break command.
For more information, see “Entering the ok Prompt” on page 33.
Stop-N Function
The Stop-N function is not available. However, you can reset OpenBoot
configuration variables to their default values by completing the following steps,
provided the system console is configured to be accessible using either the serial
management port or the network management port.
▼
To Emulate the Stop-N Function
1. Log in to the ALOM system controller.
2. Type the following command:
sc> bootmode reset_nvram
sc>
SC Alert: SC set bootmode to reset_nvram, will expire
20030218184441.
bootmode
Bootmode: reset_nvram
Expires TUE FEB 18 18:44:41 2003
This command resets the default OpenBoot configuration variables.
3. To reset the system, type the following command:
sc> reset
Are you sure you want to reset the system [y/n]?
sc> console
y
104 Sun Fire V445 Server Administration Guide • August 2006