Sun Fire V445 Server Administration Guide - SCN Research

More documents

Recommendations

Info

2. To verify that the device has been removed from the device tree, type the following command: # cfgadm -al Ap_Id Type Receptacle Occupant Condition c0 scsi-bus connected configured unknown c0::dsk/c0t0d0 CD-ROM connected configured unknown c1 scsi-bus connected configured unknown c1::dsk/c1t0d0 disk connected configured unknown c1::dsk/c1t1d0 disk connected configured unknown c1::dsk/c1t2d0 disk connected configured unknown c1::dsk/c1t3d0 unavailable connected unconfigured unknown c2 scsi-bus connected configured unknown c2::dsk/c2t2d0 disk connected configured unknown usb0/1 unknown empty unconfigured ok usb0/2 unknown empty unconfigured ok usb1/1 unknown empty unconfigured ok usb1/2 unknown empty unconfigured ok # c1t3d0 is now unavailable and unconfigured. The corresponding disk drive OK-to-Remove indicator is lit. 3. Remove the disk drive, as described in the Sun Fire V445 Server Parts Installation and Removal Guide. The blue OK-to-Remove indicator goes out when you remove the disk drive. 4. Install a new disk drive, as described in the Sun Fire V445 Server Parts Installation and Removal Guide. 5. To configure the new disk drive, type the following command: # cfgadm -c configure Ap-Id For example: # cfgadm -c configure c1::dsk/c1t3d0 The green Activity indicator flashes as the new disk at c1t3d0 is added to the device tree. 126 Sun Fire V445 Server Administration Guide • August 2006
6. To verify that the new disk drive is in the device tree, type the following command: # cfgadm -al Ap_Id Type Receptacle Occupant Condition c0 scsi-bus connected configured unknown c0::dsk/c0t0d0 CD-ROM connected configured unknown c1 scsi-bus connected configured unknown c1::dsk/c1t0d0 disk connected configured unknown c1::dsk/c1t1d0 disk connected configured unknown c1::dsk/c1t2d0 disk connected configured unknown c1::dsk/c1t3d0 disk connected configured unknown c2 scsi-bus connected configured unknown c2::dsk/c2t2d0 disk connected configured unknown usb0/1 unknown empty unconfigured ok usb0/2 unknown empty unconfigured ok usb1/1 unknown empty unconfigured ok usb1/2 unknown empty unconfigured ok # Note that c1t3d0 is now listed as configured. Chapter 6 Managing Disk Volumes 127
Page 1 and 2:
Sun Fire V445 Server Administratio
Page 3 and 4:
Contents Preface xxi 1. System Over
Page 5 and 6:
Ways of Reaching the sc> Prompt 32
Page 7 and 8:
Memory Interleaving 70 Independent
Page 9 and 10:
▼ To Enable the Hardware Watchdog
Page 11 and 12:
Reference for Estimating System Boo
Page 13 and 14:
About Sun Management Center 204 How
Page 15 and 16:
Reference for Clearance and Service
Page 17 and 18:
Figures FIGURE 1-1 Front Panel Feat
Page 19 and 20:
Tables TABLE 1-1 Sun Fire V445 Serv
Page 21 and 22:
Preface The Sun Fire V445 Server Ad
Page 23 and 24:
Typographic Conventions TABLE P-1 T
Page 25 and 26:
http://www.sun.com/hwdocs/feedback
Page 27 and 28:
CHAPTER 1 System Overview This chap
Page 29 and 30:
TABLE 1-1 Feature Sun Fire V445 Ser
Page 31 and 32:
RAID 0,1 Internal Hard Drives Inter
Page 33 and 34:
technology enables Sun systems to a
Page 35 and 36:
For information about front panel c
Page 37 and 38:
For hard disk drive indicator descr
Page 39 and 40:
SAS Disk Drives The system has up t
Page 41 and 42:
Locating Back Panel Features The il
Page 43 and 44:
PCI0 PCI1 PCI6 PCI7 PCI2 PCI3 PCI5
Page 45 and 46:
Serial Management Port The serial m
Page 47 and 48:
Reliability, Availability, and Serv
Page 49 and 50:
CHAPTER 2 Configuring the System Co
Page 51 and 52:
TABLE 2-1 Ways of Communicating Wit
Page 53 and 54:
Default System Console Connection T
Page 55 and 56:
Access Through the Network Manageme
Page 57 and 58:
About the sc> Prompt The ALOM syste
Page 59 and 60:
About the ok Prompt A Sun Fire V445
Page 61 and 62:
L1-A (Stop-A) Keys or Break Key Whe
Page 63 and 64:
System Console ok NET MGT or SERIAL
Page 65 and 66:
4. Refer to TABLE 2-2 for instructi
Page 67 and 68:
Note - The network management port
Page 69 and 70:
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
Page 71 and 72:
2. To cause the changes to take eff
Page 73 and 74:
3. In a shell tool window on the Su
Page 75 and 76:
Modifying the /etc/remote File This
Page 77 and 78:
Accessing the System Console With a
Page 79 and 80:
If you have redirected the system c
Page 81 and 82:
6. Obtain the ok prompt. For more i
Page 83 and 84:
CHAPTER 3 Powering On and Powering
Page 85 and 86:
Powering On the Server Locally Do n
Page 87 and 88:
Caution - Applications running on t
Page 89 and 90:
the OS to recognize the configurati
Page 91 and 92:
If the system encounters a problem
Page 93 and 94:
CHAPTER 4 Configuring Hardware This
Page 95 and 96:
1 0 1 0 DIMM group 1 DIMM group 0 F
Page 97 and 98:
DIMM Configuration Rules ■ ■
Page 99 and 100:
Caution - Although access to the AL
Page 101 and 102: ■ your configuration requires a h
Page 103 and 104: PCI0 PCI1 PCI6 PCI7 PCI3 PCI2 PCI5
Page 105 and 106: About the SAS Backplane The Sun Fir
Page 107 and 108: For additional information, see “
Page 109 and 110: The Solaris Volume Manager software
Page 111 and 112: A power supply can be hot-swapped o
Page 113 and 114: FIGURE 4-7 System Fan Trays and Fan
Page 115 and 116: About the USB Ports The system fron
Page 117 and 118: CHAPTER 5 Managing RAS Features and
Page 119 and 120: power supplies, fan trays, and USB
Page 121 and 122: detects the failure and generates a
Page 123 and 124: (striping with interleaved parity).
Page 125 and 126: For instructions on connecting to t
Page 127 and 128: Viewing Environmental Information U
Page 129 and 130: ● From the ALOM system controller
Page 131 and 132: 4. To view console output as the sy
Page 133 and 134: TABLE 5-1 Device Identifiers and De
Page 135 and 136: ▼ To Enable the Hardware Watchdog
Page 137 and 138: CHAPTER 6 Managing Disk Volumes Thi
Page 139 and 140: Sun StorEdge Traffic Manager A newe
Page 141 and 142: RAID 0 - Disk Striping Disk stripin
Page 143 and 144: Caution - Creating or restoring a d
Page 145 and 146: 2. Type the following command: # ra
Page 147 and 148: 3. To confirm that you have deleted
Page 149 and 150: 4. To check the status of a RAID re
Page 151: Note that while you can use the Sol
Page 155 and 156: CHAPTER 7 Managing Network Interfac
Page 157 and 158: Attaching a Twisted-Pair Ethernet C
Page 159 and 160: During installation of the Solaris
Page 161 and 162: The name of the file you create sho
Page 163 and 164: CHAPTER 8 Diagnostics This chapter
Page 165 and 166: TABLE 8-1 Summary of Diagnostic Too
Page 167 and 168: TABLE 8-2 Component What ALOM Monit
Page 169 and 170: About Status Indicators For a summa
Page 171 and 172: ■ ■ diag-switch? parameter has
Page 173 and 174: TABLE 8-3 OpenBoot Configuration Va
Page 175 and 176: Note that service mode does not cha
Page 177 and 178: When you are deciding whether to en
Page 179 and 180: If you specify settings for neither
Page 181 and 182: If you need to know the approximate
Page 183 and 184: The following sample shows the firm
Page 185 and 186: CODE EXAMPLE 8-1 Executing Power On
Page 187 and 188: System Reset skip_diag System Contr
Page 189 and 190: TABLE 8-6 Summary of Diagnostic Ope
Page 191 and 192: 4. You can also run all tests, type
Page 193 and 194: To customize an individual test, yo
Page 195 and 196: The following is sample output from
Page 197 and 198: show-devs Command The show-devs com
Page 199 and 200: Use the following web site to inter
Page 201 and 202: # fmdump TIME UUID SUNW-MSG-ID Jul
Page 203 and 204:
# fmstat module ev_recv ev_acpt wai
Page 205 and 206:
Using the prtconf Command The prtco
Page 207 and 208:
CODE EXAMPLE 8-7 prtdiag Command Ou
Page 209 and 210:
CODE EXAMPLE 8-7 MB/FT0/F0 TACH oka
Page 211 and 212:
The prtfru command can display this
Page 213 and 214:
CODE EXAMPLE 8-12 prtfru -c Command
Page 215 and 216:
When used with the -p option, this
Page 217 and 218:
▼ To View and Set OpenBoot Config
Page 219 and 220:
Using the probe-ide Command To Conf
Page 221 and 222:
If the kernel hangs and the watchdo
Page 223 and 224:
Error Handling Summary Error handli
Page 225 and 226:
Automatic System Restoration User C
Page 227 and 228:
About SunVTS SunVTS is a software s
Page 229 and 230:
TABLE 8-12 SunVTS Test vmemtest env
Page 231 and 232:
TABLE 8-14 Feature Sun Management C
Page 233 and 234:
Interoperability With Third-Party M
Page 235 and 236:
CHAPTER 9 Troubleshooting This chap
Page 237 and 238:
■ ■ Sun System Handbook - A doc
Page 239 and 240:
About Sun Remote Services Net Conne
Page 241 and 242:
Remote Troubleshooting Capabilities
Page 243 and 244:
core dump directory to another loca
Page 245 and 246:
4. Type the df -k1 command to ident
Page 247 and 248:
APPENDIX A Connector Pinouts This a
Page 249 and 250:
Network Management Connector Diagra
Page 251 and 252:
Reference for the USB Connectors Tw
Page 253 and 254:
APPENDIX B System Specifications Th
Page 255 and 256:
TABLE B-2 Electrical Specifications
Page 257 and 258:
Reference for Clearance and Service
Page 259 and 260:
APPENDIX C OpenBoot Configuration V
Page 261 and 262:
TABLE C-1 OpenBoot Configuration Va
Page 263 and 264:
Index Symbols /etc/hostname file, 1
Page 265 and 266:
dual inline memory modules (DIMMs),
Page 267 and 268:
configuring IP address, 41 configur
Page 269 and 270:
SEAM (Sun Enterprise Authentication
Page 271 and 272:
W watchdog, hardware, See hardware
show all

Sun Fire V445 Server Administration Guide - SCN Research

Create successful ePaper yourself

Delete template?

Save as template?