Sun Fire V445 Server Administration Guide - SCN Research

More documents

Recommendations

Info

Reference for the Gigabit Ethernet Connectors Four RJ-45 Gigabit Ethernet connectors (NET0, NET1, NET2, NET3) are located on the system motherboard and can be accessed from the back panel. The Ethernet interfaces operate at 10 Mbit/sec, 100 Mbit/sec, and 1000 Mbit/sec. Gigabit Ethernet Connector Diagram FIGURE A-5 Gigabit Ethernet Connector Diagram Gigabit Ethernet Connector Signals For Gigabit Ethernet connector signals, see TABLE A-5. TABLE A-5 Gigabit Ethernet connector signals Pin Signal Description Pin Signal Description 1 Transmit/Receive Data 0 + 5 Transmit/Receive Data 2 – 2 Transmit/Receive Data 0 – 6 Transmit/Receive Data 1 – 3 Transmit/Receive Data 1 + 7 Transmit/Receive Data 3 + 4 Transmit/Receive Data 2 + 8 Transmit/Receive Data 3 – 226 Sun Fire V445 Server Administration Guide • August 2006
APPENDIX B System Specifications This appendix provides the following specifications for the Sun Fire V445 server: ■ “Reference for Physical Specifications” on page 228 ■ “Reference for Electrical Specifications” on page 228 ■ “Reference for Environmental Specifications” on page 229 ■ “Reference for Agency Compliance Specifications” on page 230 ■ “Reference for Clearance and Service Access Specifications” on page 231 227
Page 1 and 2:
Sun Fire V445 Server Administratio
Page 3 and 4:
Contents Preface xxi 1. System Over
Page 5 and 6:
Ways of Reaching the sc> Prompt 32
Page 7 and 8:
Memory Interleaving 70 Independent
Page 9 and 10:
▼ To Enable the Hardware Watchdog
Page 11 and 12:
Reference for Estimating System Boo
Page 13 and 14:
About Sun Management Center 204 How
Page 15 and 16:
Reference for Clearance and Service
Page 17 and 18:
Figures FIGURE 1-1 Front Panel Feat
Page 19 and 20:
Tables TABLE 1-1 Sun Fire V445 Serv
Page 21 and 22:
Preface The Sun Fire V445 Server Ad
Page 23 and 24:
Typographic Conventions TABLE P-1 T
Page 25 and 26:
http://www.sun.com/hwdocs/feedback
Page 27 and 28:
CHAPTER 1 System Overview This chap
Page 29 and 30:
TABLE 1-1 Feature Sun Fire V445 Ser
Page 31 and 32:
RAID 0,1 Internal Hard Drives Inter
Page 33 and 34:
technology enables Sun systems to a
Page 35 and 36:
For information about front panel c
Page 37 and 38:
For hard disk drive indicator descr
Page 39 and 40:
SAS Disk Drives The system has up t
Page 41 and 42:
Locating Back Panel Features The il
Page 43 and 44:
PCI0 PCI1 PCI6 PCI7 PCI2 PCI3 PCI5
Page 45 and 46:
Serial Management Port The serial m
Page 47 and 48:
Reliability, Availability, and Serv
Page 49 and 50:
CHAPTER 2 Configuring the System Co
Page 51 and 52:
TABLE 2-1 Ways of Communicating Wit
Page 53 and 54:
Default System Console Connection T
Page 55 and 56:
Access Through the Network Manageme
Page 57 and 58:
About the sc> Prompt The ALOM syste
Page 59 and 60:
About the ok Prompt A Sun Fire V445
Page 61 and 62:
L1-A (Stop-A) Keys or Break Key Whe
Page 63 and 64:
System Console ok NET MGT or SERIAL
Page 65 and 66:
4. Refer to TABLE 2-2 for instructi
Page 67 and 68:
Note - The network management port
Page 69 and 70:
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
Page 71 and 72:
2. To cause the changes to take eff
Page 73 and 74:
3. In a shell tool window on the Su
Page 75 and 76:
Modifying the /etc/remote File This
Page 77 and 78:
Accessing the System Console With a
Page 79 and 80:
If you have redirected the system c
Page 81 and 82:
6. Obtain the ok prompt. For more i
Page 83 and 84:
CHAPTER 3 Powering On and Powering
Page 85 and 86:
Powering On the Server Locally Do n
Page 87 and 88:
Caution - Applications running on t
Page 89 and 90:
the OS to recognize the configurati
Page 91 and 92:
If the system encounters a problem
Page 93 and 94:
CHAPTER 4 Configuring Hardware This
Page 95 and 96:
1 0 1 0 DIMM group 1 DIMM group 0 F
Page 97 and 98:
DIMM Configuration Rules ■ ■
Page 99 and 100:
Caution - Although access to the AL
Page 101 and 102:
■ your configuration requires a h
Page 103 and 104:
PCI0 PCI1 PCI6 PCI7 PCI3 PCI2 PCI5
Page 105 and 106:
About the SAS Backplane The Sun Fir
Page 107 and 108:
For additional information, see “
Page 109 and 110:
The Solaris Volume Manager software
Page 111 and 112:
A power supply can be hot-swapped o
Page 113 and 114:
FIGURE 4-7 System Fan Trays and Fan
Page 115 and 116:
About the USB Ports The system fron
Page 117 and 118:
CHAPTER 5 Managing RAS Features and
Page 119 and 120:
power supplies, fan trays, and USB
Page 121 and 122:
detects the failure and generates a
Page 123 and 124:
(striping with interleaved parity).
Page 125 and 126:
For instructions on connecting to t
Page 127 and 128:
Viewing Environmental Information U
Page 129 and 130:
● From the ALOM system controller
Page 131 and 132:
4. To view console output as the sy
Page 133 and 134:
TABLE 5-1 Device Identifiers and De
Page 135 and 136:
▼ To Enable the Hardware Watchdog
Page 137 and 138:
CHAPTER 6 Managing Disk Volumes Thi
Page 139 and 140:
Sun StorEdge Traffic Manager A newe
Page 141 and 142:
RAID 0 - Disk Striping Disk stripin
Page 143 and 144:
Caution - Creating or restoring a d
Page 145 and 146:
2. Type the following command: # ra
Page 147 and 148:
3. To confirm that you have deleted
Page 149 and 150:
4. To check the status of a RAID re
Page 151 and 152:
Note that while you can use the Sol
Page 153 and 154:
6. To verify that the new disk driv
Page 155 and 156:
CHAPTER 7 Managing Network Interfac
Page 157 and 158:
Attaching a Twisted-Pair Ethernet C
Page 159 and 160:
During installation of the Solaris
Page 161 and 162:
The name of the file you create sho
Page 163 and 164:
CHAPTER 8 Diagnostics This chapter
Page 165 and 166:
TABLE 8-1 Summary of Diagnostic Too
Page 167 and 168:
TABLE 8-2 Component What ALOM Monit
Page 169 and 170:
About Status Indicators For a summa
Page 171 and 172:
■ ■ diag-switch? parameter has
Page 173 and 174:
TABLE 8-3 OpenBoot Configuration Va
Page 175 and 176:
Note that service mode does not cha
Page 177 and 178:
When you are deciding whether to en
Page 179 and 180:
If you specify settings for neither
Page 181 and 182:
If you need to know the approximate
Page 183 and 184:
The following sample shows the firm
Page 185 and 186:
CODE EXAMPLE 8-1 Executing Power On
Page 187 and 188:
System Reset skip_diag System Contr
Page 189 and 190:
TABLE 8-6 Summary of Diagnostic Ope
Page 191 and 192:
4. You can also run all tests, type
Page 193 and 194:
To customize an individual test, yo
Page 195 and 196:
The following is sample output from
Page 197 and 198:
show-devs Command The show-devs com
Page 199 and 200:
Use the following web site to inter
Page 201 and 202: # fmdump TIME UUID SUNW-MSG-ID Jul
Page 203 and 204: # fmstat module ev_recv ev_acpt wai
Page 205 and 206: Using the prtconf Command The prtco
Page 207 and 208: CODE EXAMPLE 8-7 prtdiag Command Ou
Page 209 and 210: CODE EXAMPLE 8-7 MB/FT0/F0 TACH oka
Page 211 and 212: The prtfru command can display this
Page 213 and 214: CODE EXAMPLE 8-12 prtfru -c Command
Page 215 and 216: When used with the -p option, this
Page 217 and 218: ▼ To View and Set OpenBoot Config
Page 219 and 220: Using the probe-ide Command To Conf
Page 221 and 222: If the kernel hangs and the watchdo
Page 223 and 224: Error Handling Summary Error handli
Page 225 and 226: Automatic System Restoration User C
Page 227 and 228: About SunVTS SunVTS is a software s
Page 229 and 230: TABLE 8-12 SunVTS Test vmemtest env
Page 231 and 232: TABLE 8-14 Feature Sun Management C
Page 233 and 234: Interoperability With Third-Party M
Page 235 and 236: CHAPTER 9 Troubleshooting This chap
Page 237 and 238: ■ ■ Sun System Handbook - A doc
Page 239 and 240: About Sun Remote Services Net Conne
Page 241 and 242: Remote Troubleshooting Capabilities
Page 243 and 244: core dump directory to another loca
Page 245 and 246: 4. Type the df -k1 command to ident
Page 247 and 248: APPENDIX A Connector Pinouts This a
Page 249 and 250: Network Management Connector Diagra
Page 251: Reference for the USB Connectors Tw
Page 255 and 256: TABLE B-2 Electrical Specifications
Page 257 and 258: Reference for Clearance and Service
Page 259 and 260: APPENDIX C OpenBoot Configuration V
Page 261 and 262: TABLE C-1 OpenBoot Configuration Va
Page 263 and 264: Index Symbols /etc/hostname file, 1
Page 265 and 266: dual inline memory modules (DIMMs),
Page 267 and 268: configuring IP address, 41 configur
Page 269 and 270: SEAM (Sun Enterprise Authentication
Page 271 and 272: W watchdog, hardware, See hardware
show all

Sun Fire V445 Server Administration Guide - SCN Research

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?