X9DR3_i-LN4F+ 1.1.indb - Supermicro
X9DR3_i-LN4F+ 1.1.indb - Supermicro
X9DR3_i-LN4F+ 1.1.indb - Supermicro
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Chapter 4: AMI BIOS<br />
to allow the system BIOS to automatically set the ASPM level for the system. Select<br />
Disabled to disable ASPM support. The options are Disabled, Force L0, and Auto.<br />
Warning: Enabling ASPM support may cause some PCI-E devices to fail!<br />
Above 4G Decoding (Available if the system supports 64-bit PCI decoding)<br />
Select Enabled to decode a PCI device that supports 64-bit in the space above 4G<br />
Address. The options are Enabled and Disabled.<br />
SMBus Address Resolution Protocol<br />
Select Enabled to dynamically assign a new unique address to a device installed<br />
in each slave drive in the SMBus (System Management Bus) when a address<br />
conflict arises to resolve an address conflict in SMBus slave drives. The options<br />
are Enabled and Disabled.<br />
CPU1 Slot 1 PCI-E 3.0 x16 OPROM/CPU1 Slot 2 PCI-E 3.0 x4 OPROM/CPU1<br />
Slot 3 PCI-E 3.0 x16 OPROM/CPU2 Slot 4 PCI-E 3.0 x16 OPROM/CPU2 Slot<br />
5 PCI-E 3.0 x16 OPROM/CPU2 Slot 6 PCI-E 3.0 x8 OPROM<br />
Select Enabled to enable Option ROM support to boot the computer using a<br />
network interface from the slots specified above. The options are Enabled and<br />
Disabled.<br />
Onboard LAN Option ROM Select<br />
Select iSCSI to use the iSCSI Option ROM to boot the computer using a network<br />
device. Select PXE (Preboot Execution Environment) to use an PXE Option ROM<br />
to boot the computer using a network device. The options are iSCSI and PXE.<br />
Load Onboard LAN1 Option ROM/Load Onboard LAN2 Option ROM/ Load<br />
Onboard LAN3 Option ROM/Load Onboard LAN4 Option ROM<br />
Select Enabled to enable the onboard LAN1 Option ROM~LAN4 Option ROM.<br />
This is to boot the computer using a network device. The default setting for LAN1<br />
Option ROM is Enabled, and the default settings for LAN2 Option ROM/LAN3<br />
Option ROM/LAN4 Option ROM are Disabled.<br />
VGA Priority<br />
Use this feature to select the graphics adapter to be used as the primary boot<br />
device. The options are Onboard and Offboard.<br />
Network Stack<br />
Select Enabled enable PXE (Preboot Execution Environment) or UEFI (Unified<br />
Extensible Firmware Interface) for network stack support. The options are Enabled<br />
and Disabled.<br />
4-17