Telemetry Module MT-102 User's Manual - BlueNote Communications

The Address is 16 bit long (two bytes) in sequence „Low”
and „High” byte
Default value n/a
Comments - setting the parameter to n/a switches routing off
CAUTION!
When Channel reservation and Routing are used simultaneously, channel
reservation has higher priority. Routing table is used only without channel
reservation! In case of channel reservation, all frames are sent to one
recipient regardless format and length of the frame. After channel is
released (after channel reservation time has elapsed), the recipient is found
on the basing of the address field of received frame.
8.2.5.1.1.5. Address offset
Function - defines the offset of address field in transmitted data frame
Data type - number
Range - 0…1407
Default value 0
Comments - too short frames with lengths not encompassing address field
which are ignored. Pay attention to proper setting of Max.length
of data packet and Data packet delimiter so that all data frames
will be received completely.
8.2.5.1.1.6. Broadcast address
Function - Defines recipient address. If detected in address field of the
frame received at PORT 2 will cause sending of this frame to all
recipients defined in routing table.
Data type - number
Range - 0…65535
Default value 0
Comments - Placing this address in routing table will result in sending all
transmitted frames to corresponding IP address.
8.2.5.1.1.7. Routing table size
Function - Defines size of routing table
Data type - number
Range - 1…256
Default value - 1
Comments - the length of routing table should not be shorter than number of
network nodes the module communicates with.
8.2.5.1.2. Routing table
Idx - index number of the list
number IP - IP address of GPRS network node
47