Telemetry Module MT-102 User's Manual - BlueNote Communications

It is recommended to set filtering constant to values 6,4 and
higher to provide satisfying precision of measurements.
Assuming that measured value will raise from minimum to
maximum value (unit step), value from measurement will achieve
X% of real value within time specified by table:
Time of measurement Percent of real value
1 filtering constant 63,2%
2 filtering constants 86,5%
3 filtering constants 95,0%
4 filtering constants 98,2%
5 filtering constants 99,3%
8.2.6.2.1.2.2.1. Engineering units
Function - Defines a name for engineering units
Data type - text
Range - letters and numerals, max 16 characters
Default - x
value
Comments - inserted text does not have any influence on the value of
measured analogue signal
8.2.6.2.1.2.2.2. Low reference - internal units
Function - used along with other reference parameters for rescaling input
signal range to engineering units range.
Data type - number
Range - 0…65535
Default - 0
value
Comments - low reference point for internal units
8.2.6.2.1.2.2.3. Low reference - engineering units
Function - used along with other reference parameters for rescaling input
signal range to engineering units range.
Data type - number
Range - 0…65535
Default - 400
value
Comments - low reference point for engineering units
8.2.6.2.1.2.2.4. High reference - internal units
Function - used along with other reference parameters for rescaling input
signal range to engineering units range.
Data type - number
62