SB-10 USER'S MANUAL

More documents

Recommendations

Info

• SET PRINTER OFF-LINE This command causes the printer to set itself off-line, disregarding all subsequent characters and function codes (with the exception of < DC1 >, which returns the printer to its on-line state). When the ON LINE lamp on the printer is off, the printer will not respond to . ! * CODE: k HEX: 13 L * DECIMAL: 19 li BASIC: L CHR$(lS) REFERENCE: < DC1 > b • SET THE PRINTER ON-LINE This code resets the printer to an on-line state, allowing it to again I * receive and process characters and function codes. The ON LINE lamp must be lit for the printer to respond to this code. L CODE: . HEX: 11 DECIMAL: 17 BASIC: REFERENCE: CHR$(17) < DC3>. • SOUND THE PRINTER BELL This command causes the printer tone to sound for approximately 1/4th second. CODE: HEX: 07 DECIMAL: 7 BASIC: CHRW) REFERENCE: y 1, y0. 91
• DISABLE THE PRINTER BELL This command causes the printer to ignore the < BEL > code. CODE: y0 HEX: lB7900 DECIMAL: 27 121 0 BASIC: CHR$(27) CHR$(121) CHR$(O) REFERENCE: y 1, • ENABLE PRINTER BELL This command causes the printer to respond to the < BEL > code by sounding the printer tone. - CODE: y 1 HEX: lB7901 DECIMAL: 27 121 1 BASIC: CHR$(27) CHR$(121) CHR$(l) REFERENCE: y0, . • DISABLE PAPER-OUT DETECTOR This command causes the printer to disregard the signal sent by the paper-out detector. The paper-out signal normally sounds the printer bell and stops printing until paper is inserted and the printer is reset. CODE: 8 - _ - HEX: 1838 DECIMAL: 27 56 BASIC: CHR$(27) CHR$(56) - REFERENCE: 9. 92 -
Page 1 and 2: - \ - - - - - - - - -
Page 3 and 4: FONT STYLES AND PRINT CONTROLS -
Page 5 and 6: • CANCEL PROPORTIONAL SPAClNG Thi
Page 7 and 8: w SELECT EXPANDED PRINT This instru
Page 9 and 10: • SELECT EMPHASIZED PRINTING This
Page 11 and 12: • CANCEL SUPERSCRIPTS AND SUBSCRI
Page 13 and 14: • REVERSE THE PAPER ONE LINE (REV
Page 15 and 16: • ;yHNGE THE LINE SPACING TO nI60
Page 17 and 18: • ADVANCE PAPER TO TOP OF NEXT PA
Page 19 and 20: • SET THE BOTTOM MARGlN With this
Page 21 and 22: • ADVANCE THE PAPER “n” LINES
Page 23 and 24: • SET THE LEFT MARGIN You can use
Page 25 and 26: I SKIP HORIZONTAL TAB POSITIONS Cau
Page 27 and 28: • PRINT 24-BIT GRAPHICS - With th
Page 29 and 30: Table A-l. Options for the master p
Page 31: • scELLTHE VALUE OF THE 8TH DATA
Page 35 and 36: • SELECT INCREMENTAL MODE This co
Page 37 and 38: Printer Installation Menu contains
Page 39 and 40: • USER FUNCTIONS Once you have en
Page 41 and 42: MEMO -- -.
Page 43 and 44: STANDARD ASCII CODES DECIMAL HEXADE
Page 45 and 46: STANDARD ASCII CODES DECIMAL HEXADE
Page 47 and 48: - STANDARD ASCII CODES DECIMAL HEXA
Page 49 and 50: MEMO - - - 108
Page 51 and 52: 2-l Selection of 2-2 international
Page 53 and 54: Decimal Character 54 6 6 91 55 7 7
Page 55 and 56: Decimal Character 208 1. 209 i 270
Page 57 and 58: Graphics Data : i I ] 7.bit Interfa
Page 59 and 60: • PRINTING 8-61-r GRAPHICS In 8-b
Page 61 and 62: 70 NEXT J 80 FOR J==6 TO 0 STEP -1
Page 63 and 64: 140 DATA 1,,2,4,12,8,16,16,48,32 15
Page 65 and 66: A! LINE 70 LINE 80 LINE 90 Prints t
Page 67 and 68: Character matrix 24 dot x 13 dot st
Page 69 and 70: • SERIAL INTERFACE(OPTIONAL) Inte
Page 71 and 72: ACK I I I ;-$-_I DATA ; 9p5ec. Appr
Page 73 and 74: • THE SERIAL INTERFACE(OPTlONAL)
Page 75 and 76: Serial busy protocols In these prot
Page 77 and 78: Table H-3. Connector signals for th
Page 79 and 80: • Hexadecimal codes18 Horizontal
Page 81 and 82: Federal Communications Commission R
Page 83 and 84:
shipping costs incurred in presenti
Page 85 and 86:
COMMAND QUICK REFERENCE Print Sty/e
Page 87:
! c L / I Graphics Controls yun,u
show all

SB-10 USER'S MANUAL

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?