SB-10 USER'S MANUAL

More documents

Recommendations

Info

L • PAPER AND RIBBON Single-sheet 5.5 - 8.5 inches wide paper 0.07 - 0.10 mm thick (1 part) L c Sprocketfeed paper 4 - 10 inches wide 0.07 - 0.10 mm thick (1 part) 0.28 mm thick (3-part copies) L L Ribbon • PRINTER Width Black nylon ribbon cassette, multistrike, endless 420 mm (16.5 in.) cc. Depth 368 mm (14.5 in.) b‘” Height 148 mm (5.8 in.) Ill.“. Weight Power 11 kg (approx.) 120VAC + /-1 O%, 60 Hz, approx. 100 watts Operating 10 - 40 deg. C (50 - 104 deg. F) environment 20 - 80% relative humidity, noncondensing I Paper feed system Sprocket and friction feed L. Buffer l-line, expandable to 128K L * L I L - • PARALLEL INTERFACE (STANDARD) Interface Centronics-compatible Transfer rate 1.000 - 6,000 cps Synchron- By externally-supplied STROBE pulses ization Handshaking Logic level By ACK and BUSY signals TTL-compatible 127
• SERIAL INTERFACE(OPTIONAL) Interface RS-232C levels/20mA current loop (selectable) Transfer rate Word length Handshaking RS-232C: 150 - 19,200 bits per second (selectable) Current loop: 150 - 9,600 bits per second 1 start bit, 7 or 8 data bits, 1 or 2 stop bits; odd, even or no parity By ACK, BUSY and XONIXOFF signals (selectable) - Signal Mark: logic “1” (-3V to -15V or current on) polarity Space: logic “0” (+3V to + 15V or current off) • IEEE-488 INTERFACE(OPTIONAL) - see Appendix H 128
Page 1 and 2:
- \ - - - - - - - - -
Page 3 and 4:
FONT STYLES AND PRINT CONTROLS -
Page 5 and 6:
• CANCEL PROPORTIONAL SPAClNG Thi
Page 7 and 8:
w SELECT EXPANDED PRINT This instru
Page 9 and 10:
• SELECT EMPHASIZED PRINTING This
Page 11 and 12:
• CANCEL SUPERSCRIPTS AND SUBSCRI
Page 13 and 14:
• REVERSE THE PAPER ONE LINE (REV
Page 15 and 16:
• ;yHNGE THE LINE SPACING TO nI60
Page 17 and 18: • ADVANCE PAPER TO TOP OF NEXT PA
Page 19 and 20: • SET THE BOTTOM MARGlN With this
Page 21 and 22: • ADVANCE THE PAPER “n” LINES
Page 23 and 24: • SET THE LEFT MARGIN You can use
Page 25 and 26: I SKIP HORIZONTAL TAB POSITIONS Cau
Page 27 and 28: • PRINT 24-BIT GRAPHICS - With th
Page 29 and 30: Table A-l. Options for the master p
Page 31 and 32: • scELLTHE VALUE OF THE 8TH DATA
Page 33 and 34: • DISABLE THE PRINTER BELL This c
Page 35 and 36: • SELECT INCREMENTAL MODE This co
Page 37 and 38: Printer Installation Menu contains
Page 39 and 40: • USER FUNCTIONS Once you have en
Page 41 and 42: MEMO -- -.
Page 43 and 44: STANDARD ASCII CODES DECIMAL HEXADE
Page 45 and 46: STANDARD ASCII CODES DECIMAL HEXADE
Page 47 and 48: - STANDARD ASCII CODES DECIMAL HEXA
Page 49 and 50: MEMO - - - 108
Page 51 and 52: 2-l Selection of 2-2 international
Page 53 and 54: Decimal Character 54 6 6 91 55 7 7
Page 55 and 56: Decimal Character 208 1. 209 i 270
Page 57 and 58: Graphics Data : i I ] 7.bit Interfa
Page 59 and 60: • PRINTING 8-61-r GRAPHICS In 8-b
Page 61 and 62: 70 NEXT J 80 FOR J==6 TO 0 STEP -1
Page 63 and 64: 140 DATA 1,,2,4,12,8,16,16,48,32 15
Page 65 and 66: A! LINE 70 LINE 80 LINE 90 Prints t
Page 67: Character matrix 24 dot x 13 dot st
Page 71 and 72: ACK I I I ;-$-_I DATA ; 9p5ec. Appr
Page 73 and 74: • THE SERIAL INTERFACE(OPTlONAL)
Page 75 and 76: Serial busy protocols In these prot
Page 77 and 78: Table H-3. Connector signals for th
Page 79 and 80: • Hexadecimal codes18 Horizontal
Page 81 and 82: Federal Communications Commission R
Page 83 and 84: shipping costs incurred in presenti
Page 85 and 86: COMMAND QUICK REFERENCE Print Sty/e
Page 87: ! c L / I Graphics Controls yun,u
show all

SB-10 USER'S MANUAL

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?