DELTA Switches and Socket Outlets Catalog ET D1 · 2011 - Sobel.rs

A,B,C,/,Hand s / w
A,B,C,/,Hand s / w
Technical Information
Shutter/Blind Controls
© Siemens AG 2011
Comfort shutter/blind controls
■ Overview
Comfort shutter/
blind clock
Shutter/blind
control insert
Comfort shutter/
blind control
Sun sensor
(optional)
5TC1 526
Prog Zufall Astro
Uh
Da
C
Mode
Set
Mo
Di
Mi
Do
Fr
Sa
So
Motor
Uh
Da
C
Prog Zufall Astro
Mo
Di
Mi
Do
Fr
Sa
So
Mode
Set
N
L
I2_08802a
Form of delivery for the Comfort shutter/blind control
■ Design
I2_08803
3
The shutter/blind control insert $ is mounted in a DIN 49073-
compliant device box (recommendation: deep box).
The terminals of the insert must be directed downwards.
4
5
2
1
6
The Comfort shutter/blind clock % is plugged onto the insert
with the frame &.
The electrical contacting is achieved over the plug (.
The additional plug-in contacts ) or the socket contact * of the
Comfort shutter/blind clock are used for the adaptation of the
sensor cable.
1
2
3
4
5
6
Shutter/blind control insert
Comfort shutter/blind clock
Frame
Plug
Plug-in contacts
Socket contact
Connection options for the sun sensor cable
There are three ways to connect the sun sensor cable to the
Comfort shutter/blind control:
• Flush-mounting routing of the sun sensor cable
• Surface-mounting routing of the sun sensor cable
• Connection of the sun sensor cable by plugs
Flush-mounting routing of the sun sensor cable
1
2
1
2
3
Drilling
Cable duct
Terminal
I2_08804
3
When choosing the flush-mounting routing of the sun sensor
cable, a suitable cable must be selected. Recommendation:
J-Y(ST)Y 2 x 2 x 0.6 mm (telephone cable). The plug at the sun
sensor must be removed. The individual wires of the sensor
cable are isolated and connected with the selected cable in a
suitable manner (soldering, screw terminals or similar).
In this context, it must be ensured that the insulating tube (supplied
with the sun sensor) encloses the individual wires from the
external cable insulation to the terminal. The cable, together with
the insulating tube, is plugged through the drill hole $ of the
insert and passed through the cable duct % to the terminal &.
The terminal (supplied with the sun sensor) is put in the insert as
shown in the illustration.
19
19/54 Siemens ET D1 · 10/2010