ÐÐ°ÑÐ°Ð»Ð¾Ð³ Weidmuller: Electronics - Analogue Signal Conditioning

More documents

Recommendations

Info

Interface converter, AD/DA converter – Overview Interface converter, AD/DA converter H Isolating converter for serial interfaces and AD-/DA converter WDS2 RS232/RS485/422 Converts RS232 into RS485/422 signals WDS2 RS232/TTY Converts RS232 into TTY signals RS I/U-D8 Converts analogue current/voltage signals into an 8-bit data word RS D8-I/U Converts 8-bit data words into analogue current/voltage signals H.3
Serial interface converter Interface converter, AD/DA converter RS232/RS485/422 • 3-way isolation • RS232 connection via SUB-D 9 • RS485/422, TTY shield connection via locking bar • Switchable DTE or DCE assignment • Bidirectional communication RS232/RS485/422 RS232 U/I RS485 RS422 RS232 VCC RS485 2 - T/R (A) 2 - T/R (A) 3 - T/R (B) 3 - T/R (B) 6 - GND SHLD RS485 VCC RS232 V C WDS2 RS232/RS485/422 WDS2 RS232/RS485/422 H Technical data RS232 Connection type / Input current Assignment RS485/422 Terminating resistors Type of connection Bit distortion Bit delay Control of data direction Shield connection Status indicator Transmission rate Transmission channels Transmission distance General data Supply voltage Power consumption Ambient temperature Storage temperature Approvals Insulation coordination Standards EMC standards Rated voltage Impulse withstand voltage Pollution severity Overvoltage category Clearance & creepage distances Insulation voltage SUB-D9 (male plug) / DTE/DCE switchable with DIP switch Pull-down/pull-up via DIP switch Screw connection < 5 % ≤ 3 µs Automatic or via RS232 RTS/CTS KLBÜ 4-6/Z1 LED green: supply voltage, TxD, RxD 115.2 kBit/s Half duplex (RS485, 2-wire) Full duplex (RS485, 4-wire and RS422) Max. 1200 m twisted pair 24 V DC ± 25 % ca. 1.5 W 0 °C...+55 °C -20 °C...+85 °C cULus; GL; CE EN 50178 EN 55011, EN 61000-6-2, EN 61000-6-4 between adjacent electric circuits: 300 V between electric circuits and PE: 150 V 4 kV 2 III Between adjacent circuits: 3 mm between the circuits and PE: 1.5 mm 2 kV DC / 1 min. Dimensions Clamping range (nominal / min. / max.) Length x width x height Note mm² mm Screw connection 2.5 / 0.5 / 2.5 92.4 / 22.5 / 112.4 Ordering data Connection system Screw connection Type Qty. Order No. WDS2 RS232/RS485/422 1 8615700000 Note Accessories Cross-connector for power supplies and markers – refer to Accessories H.4
Page 1 and 2:
C A T A L O G U E 4.1 2010|2011 Ele
Page 3 and 4:
Product overview Electronics - Anal
Page 6 and 7:
Product overview - Analogue Signal
Page 8 and 9:
Introduction Product overview - Ana
Page 10 and 11:
Quick select - Analogue Signal Cond
Page 12 and 13:
Page 14 and 15:
Page 16 and 17:
Page 18 and 19:
Intrinsically safe signal condition
Page 20 and 21:
Intrinsically safe signal condition
Page 22 and 23:
ACT20X - Overview Intrinsically saf
Page 24 and 25:
NAMUR isolating switching amplifier
Page 26 and 27:
NAMUR isolating switching amplifier
Page 28 and 29:
Solenoid driver • The solenoid dr
Page 30 and 31:
Solenoid driver • The solenoid dr
Page 32 and 33:
Temperature transducer • Converts
Page 34 and 35:
Universal signal converter • Univ
Page 36 and 37:
Current supply isolator • Convert
Page 38 and 39:
Current output isolator • For con
Page 40 and 41:
Contents Signal converters and moni
Page 42 and 43:
An overview of universal signal con
Page 44 and 45:
ACT20P - Overview Signal converters
Page 46 and 47:
ACT20P - Strain gauge transmitter C
Page 48 and 49:
WAVESERIES - Overview Signal conver
Page 50 and 51:
WAVESERIES - Universal signal conve
Page 52 and 53:
Page 54 and 55:
Page 56 and 57:
WAVESERIES - DC/DC 3-way isolator C
Page 58 and 59:
WAVESERIES - DC/DC 3-way isolator 2
Page 60 and 61:
Page 62 and 63:
Page 64 and 65:
Page 66 and 67:
Signal converters and monitoring co
Page 68 and 69:
WAVESERIES - DC/DC 2-way isolator S
Page 70 and 71:
WAVESERIES - DC/DC passive isolator
Page 72 and 73:
WAVESERIES - DC/DC passive isolator
Page 74 and 75:
WAVESERIES - PT100/RTD signal isola
Page 76 and 77:
WAVESERIES - PT100/RTD - signal con
Page 78 and 79:
WAVESERIES - PT100/RTD - signal con
Page 80 and 81:
WAVESERIES - Thermocouple signal co
Page 82 and 83:
WAVESERIES - Frequency signal conve
Page 84 and 85:
WAVESERIES - Current monitoring Ana
Page 86 and 87:
WAVESERIES - Current monitoring Ana
Page 88 and 89:
CMA - Current monitoring Analogue o
Page 90 and 91:
Trip amplifier for monitoring AC/DC
Page 92 and 93:
Trip amplifier for monitoring AC/DC
Page 94 and 95:
Relay output • Current ranges adj
Page 96 and 97:
Relay output • 2-way isolation
Page 98 and 99:
Relay output • Monitoring of curr
Page 100 and 101:
Signal converters and monitoring co
Page 102 and 103:
Universal signal converter and moni
Page 104 and 105:
MICROSERIES - Overview Signal conve
Page 106 and 107:
Configurable • 3-way isolation
Page 108 and 109:
Without HART ® • 2-conductor sys
Page 110 and 111:
RTD 2-/3-wire converter • 2-way i
Page 112 and 113:
Thermo isolator/converter type K
Page 114 and 115:
Thermo isolator/converter type J
Page 116 and 117:
Pluggable interface module The Micr
Page 118 and 119:
MCZ-SERIES - Overview Signal conver
Page 120 and 121:
RTD 2-/3-wire converter • For 2-
Page 122 and 123:
Transistor output • 2 digital out
Page 124 and 125:
Contents Process monitoring Process
Page 126 and 127:
Process monitoring - Overview Proce
Page 128 and 129:
Process monitoring with analogue an
Page 130 and 131:
Page 132 and 133:
Page 134 and 135:
Page 136 and 137: Frequency isolator / transformer wi
Page 138 and 139: Frequency isolator / transformer wi
Page 140 and 141: Process monitoring with relay outpu
Page 160 and 161: Indicators and configurable display
Page 164 and 165: Counters Indicators and configurabl
Page 166 and 167: PTX800 SERIES Counter and totaliser
Page 174 and 175: PMX400 SERIES • Frequency measuri
Page 176 and 177: AMS400A Universal auto-manual stati
Page 184 and 185: Contents Interface converter, AD/DA
Page 188 and 189: Serial interface converter RS232/TT
Page 190 and 191: AD/DA converter AD converter, 8-bit
Page 192 and 193: AD/DA converter DA converter 8-bit
Page 194 and 195: Accessories Analogue Signal Conditi
Page 196 and 197: Accessories Analogue Signal Conditi
Page 198 and 199: CBX100 • Configuration interface
Page 200 and 201: Technical data Output voltage mode
Page 202 and 203: Portacal 275 Calibration device for
Page 204 and 205: WAVEBOX S 22.5 WAVEBOX L 22.5 WAVES
Page 206 and 207: Accessories MCZ MCZ-SERIES - Access
Page 208 and 209: Contents Fieldbus distributor Field
Page 210 and 211: Fieldbus distributor - Overview Fie
Page 212 and 213: Fieldbus distributor - Overview Pro
Page 214 and 215: PROFIBUS-DP PROFIBUS-DP distributor
Page 216 and 217: PROFIBUS-DP Terminator Cable gland
Page 218 and 219: PROFIBUS-PA Fieldbus distributor Th
Page 220 and 221: PROFIBUS-PA 2-channel distributor C
Page 222 and 223: PROFIBUS-PA 8-channel distributor C
Page 224 and 225: PROFIBUS-PA 1-channel distributor (
Page 232 and 233: Fieldbus distributor J J.25
Page 234 and 235: PROFIBUS-PA ATEX Approvals Fieldbus
Page 236 and 237:
PROFIBUS-PA ATEX 2-channel distribu
Page 238 and 239:
PROFIBUS-PA ATEX 8-channel distribu
Page 240 and 241:
Fieldbus distributor J J.33
Page 242 and 243:
Accessories - Customizable plug M12
Page 244 and 245:
Accessories - Positioning plug Posi
Page 246 and 247:
Contents Weidmüller Service Weidm
Page 248 and 249:
Customer specific solutions Overvie
Page 250 and 251:
Customer specific solutions Weidmü
Page 252 and 253:
Customer specific solutions Digital
Page 254 and 255:
Technical appendix/Glossary Content
Page 256 and 257:
Introduction Technical appendix/Glo
Page 258 and 259:
Technical data Technical appendix/G
Page 260 and 261:
Technical data Technical appendix/G
Page 262 and 263:
FDT/DTM - The standard solution for
Page 264 and 265:
EX basics Technical appendix/Glossa
Page 266 and 267:
Page 268 and 269:
Page 270 and 271:
Labelling for ATEX approval of a si
Page 272 and 273:
Derating curve (current-carrying ca
Page 274 and 275:
CE marking / EMC directives General
Page 276 and 277:
General technical information Techn
Page 278 and 279:
Glossary Technical appendix/Glossar
Page 280 and 281:
Page 282 and 283:
Page 284 and 285:
Page 286 and 287:
Page 288 and 289:
Page 290 and 291:
Page 292 and 293:
Page 294 and 295:
Contents Index Index Index Index Ty
Page 296 and 297:
Type Order No. Page Type Order No.
Page 298 and 299:
Order No. Type Page Order No. Type
Page 300 and 301:
Group companies Agency abroad Witho
show all

ÐÐ°ÑÐ°Ð»Ð¾Ð³ Weidmuller: Electronics - Analogue Signal Conditioning

Create successful ePaper yourself

Delete template?

Save as template?

ÐÐ°ÑÐ°Ð»Ð¾Ð³ Weidmuller: Electronics - Analogue Signal Conditioning