System description - Pilz GmbH & Co.

Modules
Digital input/output (standard)
PSSu E S 2DOR 10(-T)
3.4
3.4 PSSu-2011-01
Modules Digital Gertebild E input/output S 2DOR 10(-T) (standard)
][Bildunterschrift ST-Ausgang Relais
Electronic module with relay outputs
for standard applications
Approvals
Zulassungen
PSSu E S 2DOR 10
Module features
][Merkmale_Ein_Aus Ausgang Relais ST
2 relay contacts
– Normally open contact
– Volt-free
– Current load capacity per output:
10.0 A
][Merkmale_LED Ausgang
LEDs for:
– Switch status of each output
– Module error
][Merkmale_Zusatz ST-Module Sys A
For standard applications in system
environment A
][Geraetemerkmal_T
Coated version of the module:
PSSu E S 2DOR 10-T: for increased
environmental requirements
][Merkmale_Zusatz ST-Module
Communication via:
– Standard fieldbus
Module description
][Gertebeschreibung ST-Ausgang Relais
The module provides type 1 relay
ouputs in accordance with IEC 61131-
2. It may be used to switch:
Resistive loads
Inductive loads
][Gertebeschreibung ST-Module Sys A
The module may be used for standard
applications in system environment A.
Bestimm_Verwend_Zusatz-(T)
The module PSSu E S 2DOR 10-T is
suitable for use where there are increased
environmental requirements
(see Technical Details).
][DB Bestimmung Ausschluss ST Relais
The module may not be used in combination
with PSSu E F BSW(-T) modules
in safety-related applications.
Integrated protection mechanisms
][Schutzmechanismen E/A-Module
When the PSSu E F PS1(-T) is used to
supply the system, the module supply
is buffered for 20 ms if the supply voltage
is interrupted.
][Schutzmechanismen ST-Ausgang Relais
The module has the following protection
mechanisms:
Safe separation between both relay
contacts (see Technical details)
Safe separation between both relay
contacts and the periphery supply
as well as the module supply, in accordance
with DIN VDE 0110 overvoltage
category 2 in a protected
industrial network
Temperature monitoring
The module provides the following diagnostic
data:
Start-up error
Configuration error
ST communication error
Bus termination error
Temperature error: too warm
Temperature error: too hot
Block diagram
Blockschaltbild
12 22
32 42 31 41 34 44
11 14
Module Bus
Periphery
Supply
+ 24 V DC
Module
Supply
+ 5 V DC
Data
(ST)
K0
K1
(C-Rail)
13 23 33 43
21 24
3.4-48
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: pilz.gmbh@pilz.de
PSSu-2011-01