7. Providing services for Industrial Canteen at ONGC Mangalore ...

121. Earthling welding cable should be rigidly connected to the material being welded &securely attached at a location immediately adjacent to the welding.122. Welding cable ends should be lugged & bolted on the machine side, Holder & earthlingside. No joints will be permitted on the welding cable. Only aluminum/ copper cableshould be used for welding holder & earthling during welding.123. Grinding machines should be connected through a three core single cable with industrialplug top one side and direct to the machine on the other end. (No cable joint will bepermitted).124. All grinding machines used should have wheel guards.125. No jobs should be started without the valid work permit and to be stopped onexpiry/withdrawal of the permit. When the welder stops working the welding machineshould be shutdown & the valves on the cylinders should be closed and the pressurefrom the regulators should be released.126. All stand by firefighting equipment as mentioned in the Hot work permit to be ensuredat the place of work.127. All the workmen & Supervisor should have personal protection equipment like Helmet,Safety Shoes, gloves, Welding helmet & gloves for the welder, Goggles for Grinder &Gas Cutter. Safety belts should be used while working at heights1. GENERAL GUIDELINESa. Tender should be submitted in the prescribed form supplied by the company only.b. Every tenderer must submit bid strictly in accordance with the conditions andspecifications prescribed by OMPL. Special conditions (if any) submitted along with thetender documents by the bidder will not be applicable to this Tender, in case they are inconflict with any of our terms and conditions.c. Acceptance of Terms & Conditions: The tenderer must confirm unconditional acceptanceof Instruction to Bidders, General conditions of contract at Section-I,Special conditionsof Contract & service requirements at Secton-III. All tenderers are required to gothrough the all the pages of Tender documents and sign for unconditional acceptance ofTender document & terms & conditions therein.d. All entries in the tender must be written in permanent ink or typewritten without use oferaser or overwriting. Corrections if any, should be attested under the full signature ofthe tenderer.e. All the Rates given in the Tender must be expressed both in words and in figures and incase of difference between the two, the rates given in words would be final andconsidered correct.f. All tenderers are required to give details in the Performa attached in Section-II andattach to Technical bid.g. Bidders are required to serially number all the pages being appended by them as part ofsubmission to the Technical bid. Such numbering shall include , Covering letter,Technical specifications, Items list being offered, Drawings, Bid qualification proof,Testimonials, Certificates, Catalogues, Compliance or Deviation statements, etc asapplicable to this Tender and create an Index Page with headings and correspondingpage numbers. In addition to this, all pages of the Tender documents issued by OMPLshall be signed on all pages and submitted along with the Technical Bid.wherever bids are invited in 2 Parts,(Technical bids and Price bid separately) the Pricebid shall be sent in a separate sealed cover and in the Price bid also, all the pages arePage 25 of 74