SmartSensor HD - Interprovincial Traffic Services

CHAPTER 7 • DATA SETUP AND COLLECTION 85Figure 7.13 – Data PushTo enable data push, select the Event, Interval or Presence tab, then select which methodof communication and format you are using and turn the function on.PortThis allows you to select the SmartSensor HD communications port through which thedata will be pushed. If the sensor is pushing data on a half-duplex communication port, thesensor may not respond to commands due to collisions on the communications bus.NoteSmartSensor HD's native RS-232 and RS-485 ports are both half duplex.FormatThe following formats are available for all three data types:˽˽˽˽˽˽SS125 Format – This outputs the data in the native SS125 format (see the SmartSensorHD Released Communications Protocols document, available at www.wavetronix.com,for information on this format).SS105 Simple Format – This outputs the data in the SSHD SS105 emulation formatwithout a multi-drop header (see the SmartSensor HD Released Communications Protocolsdocument for information on this format).SS105 Multidrop Format – This outputs the data in the SSHD SS105 emulation formatwith a multi-drop header (see the SmartSensor HD Released Communications Protocolsdocument for information on this format).For Event Data, there are six additional format options. All of them output the data in Z4format. Z4 is a Wavetronix-specific protocol that allows sensors to talk to other Wavetronix