EMIS Interface Description - Measurement Solutions

Sening®
Innovative Tank Truck Systems
Specification
Euro Interface EMIS
Interface Description
Direction Telegram
EMIS REQUEST,METER,SETUP
OBC
OBC REPORT,METER,SETUP,METERCOUNT=“0“;AUTOSCAN=“1“
EMIS
EMIS is scanning the CAN-bus for measuring systems during start-up ( AUTOSCAN=“1“ ) and
did not find any systems ( METERCOUNT=“0“ ). Possible reason: measuring system(s) not
switched on.
� O OBC must perform error treatrment (e.g. display “please check measuring system(s)” ).
3 - Check if measuring systems are able to communicate
It is assumed that only one measuring system is connected to EMIS to make the further
explanations in this chapter easier. If more than one systems is connected, all procedures
described below have to be repeated for each measuring system.
Direction Telegram
EMIS REQUEST,METER,STATUS(0)
OBC
OBC REPORT,METER,STATUS(0),LASTERROR="000:Ready to receive next
order";MODE="READY"
EMIS
The measuring system is connected, in operation and ready to receive the next order
( MODE=“READY“ ).
� Proceed with the program.
Direction Telegram
EMIS REQUEST,METER,STATUS(0)
OBC
OBC REPORT,METER,STATUS(1),LASTERROR="001:Locked with actual
operation";MODE="BUSY"
EMIS
The measuring system is connected and in operation, but not able to receive the next order at
present ( MODE=“BUSY“ ). This is caused e.g. by manual input at the measuring system
(menu-mode) or a delivery in process.
� Proceed with the program for the moment.
Direction Telegram
EMIS REQUEST,METER,STATUS(0)
OBC
EMIS REQUEST,ADMIN,STATUS
OBC
REPORT,ADMIN,STATUS,LASTERROR="5100:METER device not
present";MODE="READY"
EMIS
The measuring systems does not answer the requests by EMIS.
MNF19002EUS / DOK-411E Rev. 2.00 / MB / jp / Juli 2008 59
1
2
3
4
5
6
7
8
9
A
Programming Details