EMIS Interface Description - Measurement Solutions

Sening ®
Innovative Tank Truck Systems
Appendix A
E7 Protocol – TDL formated data
Specification
Euro Interface EMIS
Interface Description
As an alternative to the “DOK-411 Communcation“, there is the additional possibility since the
emergence of the EMIS software version 3.12 to recall some information in the TDL format (see
DIN 26051-1 and DIN 26051-2). The protocol used here varies slightly from the one described
above. Communicatioin is done in keeping with the E7 specification. This involves a protocol
oriented to the DOK-411 format which 7 leading European manufacturers commercially involved
with communication on the tank truck have agreed to. The E7 specification is available as a
separate doument.
Definitions are provided for several sub-nodes in a further "TDL" designated node. The EMIS
currently supports the L_FILE, SYSTEM, GPS, PRN and AUX sub-nodes.
TDL,L_FILE
In a similar manner to QAS,EVENT, the TDL,L_FILE node can recall setup and event information.
Given that basically no other data is available, the TDL formatted output solely represents data
conversion from the setup or event table (see Chapters 4.2.1.2 and 4.2.1.3).
The entry in the setup table (TDL Identifier 800 Field index) specifies the index of the individual
setup information in the TDL string (see Setup information TDL Identifier 800).
Example from the setup table:
Setup description TYPE VALUE1 VALUE2
TDL
Identifier
800
Field index
Number of output drivers SET02 IO 0 to 4 e.g. 2 4
REPORT,TDL,L_FILE=800,20060106143800,11,FAS,2,0,0, …..
In the event table (4.2.1.3 / Page 33) conversion into the TDL format is listed in the line below.
MNF19002EUS / DOK-411E Rev. 2.00 / MB / jp / Juli 2008 73
1
2
3
4
5
6
7
8
9
A
Anhang A Protokolle