EMIS Interface Description - Measurement Solutions

Specification
Euro Interface EMIS
Interface Description
If printer is assigned to OBC:
Direction Telegram
EMIS SET,PRN,TEXT=“Lieferschein\r\n“
OBC
OBC
OBC
... ...
EMIS SET,PRN,STATUS,MODE=“READY“
Sening®
Innovative Tank Truck Systems
OBC
After discharge the measuring system(s) access the printer for printing the original receipt. The
printer access is requested from EMIS. For this reason the OBC must release the printer after
printing the header by sending
SET,PRN,STATUS,MODE=“READY“ wieder freigibt.
10 - Check if all discharges are finished
The measuring results can be found in the METER,ORDERS,RESULT(n) area. For a clear
assignment the order corresponds to the presets, i.e. RESULT(0) contains the measuring
results which correspond to PRESET(0), RESULT(1) corresponds to PRESET(1) etc.
Direction Telegram
EMIS REQUEST,METER,ORDERS,RESULT(0),Check
OBC
OBC REPORT,METER,ORDERS,RESULT(0),CHECK=““
EMIS
The result is not yet available. The procedure shown above must be performed for all expected
results.
Reasons: The discharge is not finished (in case of MultiFlow measuring systems, the actual
mode can be determined by command REQUEST,METER(n),STATUS,MODE . If EMIS reports
MODE=“BUSY“, the discharge is in progress) or the measuring system was not able to
discharge the corresponding product (e.g. the system is not configured for this product).
It must be considered that the job distribution can not be determined If several measuring
systems are connected.
� OBC must continue waiting for the result(s), interruption by the operator must be provided
(if necessary)
Direction Telegram
EMIS REQUEST,METER,ORDERS,RESULT(0),Check
OBC
OBC REPORT,METER,ORDERS,RESULT(0),CHECK=“OK“
EMIS
The result is available. The procedure shown above must be performed for all expected results.
� Proceed with the program.
64 Rev. 2.00 / MB / jp / Juli 2008 MNF19002EUS / DOK-411E