EMIS Interface Description - Measurement Solutions

Specification
Euro Interface EMIS
Interface Description
DMS Dead man's switch
824,S,NoID,FAS,0 4)
824,S,NoID,FAS,1 4)
824,S,NoID,FAS,2 4)
824,S,NoID,FAS,3 4)
TYPE V1 V2
DMS “0“ = ANA switched off
DMS “1“ = ANA switched on
DMS “2“ = ANA Alarm
DMS “3 = ANA emergency off
ACCU load communication (Connection to the ACCU load)
825,S,NoID,FAS,V1 4)
825,S,NoID,FAS,V1 4)
Water detection (Sensor status)
826,S,NoID,FAS,V1,0 4)
826,S,NoID,FAS,V1,1 4)
826,S,NoID,FAS,V1,2 4)
826,S,NoID,FAS,V1,3 4)
826,S,NoID,FAS,V1,4 4)
ALC “0“ = interrupted
ALC “1“ = connected
WTR KaNr “0“ = passiv
Sening®
Economic Tank Truck Systems
WTR KaNr “1“ = active (water in compartment)
WTR KaNr “2“ = not connected
WTR KaNr “3“ = short-circuit
WTR KaNr “4“ = invalid / unknown
3) manufacturer-specific data field expansion, which is not specified in this way in DIN 26051
4 ) new manufacturer-specific data field identifier 8xx (see appendix A …)
CoNo Compartment number 1 to n, where 1 is the tank compartment following the driver’s cab
AsNo Overfill prevention device number
PrCo Product code as per DIN 26051-1 (P53), can be extended or changed in the QAS sysstem
NoID CAN account number of the QAS unit (typical = 11)
88 Rev. 2.00 / MB / jp / Juli 2008 MNF19002EUS / DOK-411E