EMIS Interface Description - Measurement Solutions

Specification
Euro Interface EMIS
Interface Description
Sening®
Innovative Tank Truck Systems
� OBC must perform error treatment ( e.g. display “please check measuring system(s)” ).
4 - Initialisation / clear all memories and devices
Direction Telegram
EMIS SET,METER,ORDERS,REINIT=“xxx“
OBC
Initialisation of measuring system(s) and EMIS memory acknowledged.
� Proceed with the program.
Direction Telegram
EMIS SET,METER,ORDERS,REINIT=“xxx“
OBC
EMIS REQUEST,ADMIN,STATUS
OBC
OBC REPORT,ADMIN,STATUS,LASTERROR="5100:METER device not present";
MODE="READY"
EMIS
The (or one of the) measuring system(s) does not answer the requests by EMIS. The error code
will help to identify the system which caused the error (see chapter 4.8).
� OBC must perform error treatment ( e.g. display “please check measuring system(s)” ).
5 - Verify the success of the initialisation
Direction Telegram
EMIS REQUEST,METER,STATUS(0)
OBC
OBC REPORT,METER,STATUS(0),LASTERROR="000:Ready to receive next
order";MODE="READY"
EMIS
The measuring system is connected, in operation and ready to receive the next order
( MODE=“READY“ ), i.e. initialisation was sucessfull.
� Proceed with the program.
Direction Telegram
EMIS REQUEST,METER,STATUS(0)
OBC
OBC REPORT,METER,STATUS(1),LASTERROR="001:Locked with actual
operation";MODE="BUSY"
EMIS
The measuring system is connected and in operation, but not able to receive the next order at
present ( MODE=“BUSY“ ). This is caused e.g. by a delivery in process.
� OBC must perform error treatment ( e.g. display “please check measuring system(s)” ).
60 Rev. 2.00 / MB / jp / Juli 2008 MNF19002EUS / DOK-411E