EMIS Interface Description - Measurement Solutions

Sening®
Innovative Tank Truck Systems
Specification
Euro Interface EMIS
Interface Description
Direction Telegram
EMIS REQUEST,METER,STATUS(0)
OBC
EMIS REQUEST,ADMIN,STATUS
OBC
REPORT,ADMIN,STATUS,LASTERROR="5100:METER device not present";
MODE="READY"
EMIS
The measuring systems does not answer the requests by EMIS.
� OBC must perform error treatment ( e.g. display “please check measuring system(s)” ).
6 - Transmission of presets to EMIS
Direction Telegram
EMIS SET,METER,ORDERS,PRESET(0),PCODE=“1“;VOLUME=“10000“;PUNIT=“L“
OBC
EMIS SET,METER,ORDERS,PRESET(1),PCODE=“3“
OBC
EMIS SET,METER,ORDERS,PRESET(1),VOLUME=“2000“
OBC
EMIS SET,METER,ORDERS,PRESET(1),PUNIT=“L“
OBC
Up to 10 presets (index 0..9) may be transmitted for the present version of EMIS. Both presets
in the example above have been acknowledged by EMIS. The example shows two alternatives:
Transmission of all preset-information with one set command (preferred variant) or transmission
of the preset data with separate telegrams.
� Proceed with the program.
Direction Telegram
EMIS SET,METER,ORDERS,PRESET(0),PCODE=“1“
OBC
EMIS SET,METER,ORDERS,PRESET(1),PCODE=“3“
OBC
EMIS REQUEST,ADMIN,STATUS
OBC
REPORT,ADMIN,STATUS,LASTERROR="1006:Index out of range";
MODE="READY"
EMIS
Each preset has to be transmitted completely in the correct order. If one preset is not
completed, EMIS will reject the transmission of further presets.
MNF19002EUS / DOK-411E Rev. 2.00 / MB / jp / Juli 2008 61
1
2
3
4
5
6
7
8
9
A
Programming Details