Renamic - BIOTRONIK USA - News

More documents

Recommendations

Info

34 Using RenamicUsing theInternal PrinterFigure 9: Renamic paper tray for internal printerThe Renamic printer has a high-definition thermal printerthat is capable of printing graphics. The device prints onthermal folding paper. The thermal paper printouts aremoisture and heat sensitive and will fade when exposed tostrong sunlight. Make copies for permanent documentation.Inserting paperTo insert paper into the tray, follow the steps described below:Figure 10: Renamic paper tray opened
35 Using Renamic• Open the paper tray.--Open the lid by lightly pushing it upwards.ооPrinters without release lever:• Pull the tray all the way out.ооPrinters with a release lever:• Press down the key on the right side andpull the tray all the way out.Figure 11: Inserting paper into tray• Insert paper.--Press back the separating flap (clear tab locatedwithin the paper drawer).--Pull back the first page of the paper block.--Place the block of paper in the tray from above, sothat when the paper lays over the roller, the blackrectangles are facing up.--Place the separating flap under the first sheet of paper.--Pull the first page over the separating flap andrubber roller.• Close the paper tray.--Push the tray back into Renamic until it stops.--The cover locks automatically.
Page 3 and 4: 1Table of ContentsIndications for U
Page 5 and 6: 3 Table of ContentsSupplementary In
Page 7: 5Indications and Contraindications
Page 11: 9 Warnings and Precautionstouching
Page 14 and 15: 12 General Safety InstructionsGener
Page 16 and 17: 14 General Safety InstructionsElect
Page 18 and 19: 16 General Safety InstructionsSensi
Page 20 and 21: 18 Device OverviewDevice OverviewAn
Page 22 and 23: 20 Device OverviewFigure 3: Power c
Page 25 and 26: 23 Start UpECG Port and USB Device
Page 28 and 29: 26 Start UpWhen possible, use the O
Page 30 and 31: 28 Using RenamicEmergencyProgramsRe
Page 32 and 33: 30 Using RenamicTelemetryThe progra
Page 34 and 35: 32 Using RenamicLED Status (flashin
Page 38 and 39: 36 Using RenamicPrintingFigure 12:
Page 40 and 41: 38 Renamic PSAOverviewRenamic PSATh
Page 42 and 43: 40 Renamic PSAConnecting thepatient
Page 44 and 45: 42 Renamic PSAa. Rate - current rat
Page 46 and 47: 44 Renamic PSAParameter Range Remar
Page 48 and 49: 46 Renamic PSAFigure 17: Saving mea
Page 50 and 51: 48 Renamic PSAFigure 19: Burst paci
Page 52 and 53: 50 Renamic PSAFigure 21: Completed
Page 54 and 55: 52 Renamic PSAFigure 23: Sensing te
Page 56 and 57: 54 Renamic PSAFigure 25: Threshold
Page 58 and 59: 56 Renamic PSAFigure 27: Adjust scr
Page 60: 58 Renamic PSAFigure 28: The Freeze
Page 63 and 64: 61 Renamic PSAFigure 31: ID NumberF
Page 65: 63 Renamic PSAFigure 34: Date of Bi
Page 68 and 69: 66 Renamic PSAHospitaland CityThe h
Page 71 and 72: 69 Renamic PSATypeThe type of lead
Page 73 and 74: 71 Renamic PSAIf a device is interr
Page 75 and 76: 73 MaintenanceMaintenanceTo clean a
Page 77 and 78: 75 SafetyOperatingConditions• Do
Page 79 and 80: 77 Technical DataTechnical DataSee
Page 81 and 82: 79 Technical DataInternal printerCa
Page 83 and 84: 81 Supplementary InformationSupplem
Page 85 and 86: 83 Supplementary InformationUL-cert
Page 88 and 89:
86 Symbols on the ComponentsThe sym
Page 90 and 91:
88 Symbols on the ComponentsLegend
Page 94:
M4147-B 07/13© 2013 BIOTRONIK, Inc
show all

Renamic - BIOTRONIK USA - News

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?