2003 US Army BRADLEY GUNNERY 503p.pdf - Survival Books

FM 3-22.1d. Moved range-control knob to 0.e. Moved sensor-selected switch to CLEAR or NEUTRAL.3. Boresighted eye-safe laser range finder (ELRF).a. Moved magnification switch to HIGH.b. Moved TSCP power switch to on.c. Selected FIST soft key (except in FIST mode).d. Moved laser switch to ON.e. Unstowed prism boresighted knobf. Closed ballistic sight shield doors.g. Located ELRF reticle.h. Adjusted RET DSP knob.i. Adjusted RET BRT knob.j. Aligned ELRF reticle within center of TOW reticle.k. Stowed prism boresighted knob.l. Moved laser switch to OFF.m. Opened ballistic sight shield doors.4. Boresighted the M242 25-mm automatic gun.a. If in FIST mode, deselected FIST soft key.b. Pressed AP SS button.c. Ensured that "AP" appeared on status indicator.d. Adjusted RET or BRT knob for correct brightness of gun reticle.e. Moved turret-traverse, drive-select lever to manual position.f. Moved gun-elevation, drive-select lever to manual position.g. Released turret-travel lock.h. Centered gun reticle on aiming point of target.i. (Helper) installed 25-mm boresight adapter, red streamer, and boresight telescope.j. (Helper) focused boresight telescope on target.k. (Helper) aligned elevation cross hair in boresight scope on aiming point of target.l. (Helper) aligned azimuth cross hair in boresight scope on aiming point of target.m. (Helper) checked accuracy of boresight telescope.n. Aligned gun reticle on aiming point of target.o. (Helper and gunner-observer) switched positions and verified alignment.p. Removed boresight telescope, red streamer, and 25-mm boresight adapter.5. Boresighted the M240C coax machine gun.a. Pressed the 7.62 button.b. Ensured that "7.62" appeared in the status indicator.c. Ensured that the gun reticle aligned on the target's aiming point.d. Moved to the commander’s seat.e. (Helper) installed boresight adapter, red streamer, and boresight telescope.f. (Helper) focused boresight telescope on boresight panel.g. (Helper) aligned the azimuth crosshair in the boresight scope reticle on the aimingpoint of the target.h. (Helper) aligned the elevation crosshair in the boresight scope reticle on theaiming point of the target.i. (Helper) removed boresight telescope, the red streamer, and the boresight adapter.6. Boresighted the nightsight to the daysight.A-48