2003 US Army BRADLEY GUNNERY 503p.pdf - Survival Books

FM 3-22.1TEST PLANNING TIMEAdministration 5 minutesTest5 minutesTotal10 minutesINSTRUCTIONS TO EXAMINEEThe evaluator will read the following instructions aloud to the examinee:"Let me have your attention. This task evaluates your ability to set up a SINCGARSradio for digital communications. Do you understand these instructions?"Pause for 5 seconds, then say—"You have 5 minutes to complete each task."Pause again, then say--"Begin."Start timing at once. If the examinee has not completed each task after the appropriatetime, then say loudly enough for him to hear--"Stop."If at any time you think that he is going to damage the equipment or injure himself,then say--"Stop."PERFORMANCE MEASURES1. Completed performance measures within 5 minutes.2. Set up radio for digital communications.a. Adjusted DIM and VOL as required, using the menu CLR and CHG(change) keys.b. Set CHAN selected to Channel 1 using the menu CLR and CHG (change) keys.c. Adjusted power setting as required for estimated distance:• LO=less than 300 meters.• M=less than 4 kilometers.• HI=less than 8 kilometers.• PA=up to 35 kilometers.d. Set FCTN switch to LD (load).e. Loaded COMSEC and FREQ hop data using AN/CYZ.f. Set MODE to FH (frequency hopping) using menu CLR and CHG (change) keys.g. Set COMSEC to CT (cipher text), using menu CLR and CHG (change) keys.h. On the keypad, pressed FREZ then CLR. Display should have been blank.Entered frequency and pressed STO.i. Pressed DATA (4) then CHG (7) until PCKT appeared in display.j. Moved FTCH switch back to SQ ON.k. LCU configuration. Each of the following was unclassified:• Connection: RADIO.• Protocol: TACFIRE.• Modulation: NRZ.A-61