2003 US Army BRADLEY GUNNERY 503p.pdf - Survival Books

FM 3-22.1(7) You have now collected all of the data for one adapter. Continue testing until youhave tested all of the adapters from one company. Testing one adapter takes about two tofour minutes, so you can test thirteen adapters in about an hour. Test the adapters onecompany at a time until you have tested all of the equipment in the battalion, then scorethe adapters.Figure B-33. Azimuth and elevation with adapter to the left, at mark "B."Figure B-34. Left aiming point, TEST 2.c. The distance between the two aiming points is the criterion used to measureaccuracy during one iteration of a test. For the adapter to receive a GO, the distancebetween the telescope's two aiming points must measure 1 mil or less. On thescoring grid, 1 mil equals 1/2 inch. Use a standard ruler to measure the distance betweenpoints. For an adapter to score a GO, the distance must measure no more than 1/2 inch.To pass the screening test, it must score a GO on both Tests 1 and 2. The following stepsfor scoring the adapter are based on the previous example:B-22