SPW Product Catalogue 2019

1
ACCESSORIES
L.I.T. PROCESS
A safer method of igniting Thermic Lances, which eliminates the use of any fuel gases (eg.
Acetylene, LPG) in the area. One Lance Igniter Tube can ignite up to 35 Thermic Lances and 50
Mini Thermic Lances.
PRODUCT No
IT400
lw1000
DESCRIPTION
Lance Igniter Tube
Lance Wick
How Does L.I.T. Work?
1. You ignite the Lance Wick with a match. The Wick then smoulders very slowly.
2. You place the Lance over the face of the Igniter Tube and your assistant places the smouldering Wick in
the same position.
3. You apply oxygen at low pressure. The Wick flares into a flame and lights the Igniter Tube.
4. You remove the Wick and place the Lance 30mm inside the centre of the Igniter Tube.
5. Your assistant can slowly increase oxygen pressure at the Regulator, which causes a fierce flame to heat
up end of Lance. This ignites the Lance, as shown in the picture.
NUTS, RUBBERS, HOLDERS, AND LANCING RODS
NUTS
RUBBERS
PRODUCT No DESCRIPTION PRODUCT No DESCRIPTION
NUT12 Lance Locking Nut (12mm) RUBBER12 Lance Locking Rubber (12mm)
NUT16 Lance Locking Nut (16mm) RUBBER16 Lance Locking Rubber (16mm)
NUT19 Lance Locking Nut (19mm) RUBBER19 Lance Locking Rubber (19mm)
WELDING EQUIPMENT
14 SPW GROUP PTY LTD