WARNING - Flannery Plant Hire

Blade and Track Width Control Lever Operation
(ZX18-3)
OPERATING MACHINE
d CAUTION:
• Be sure to set the track width to either 1280 mm
(fully extended) or 970 mm (fully retracted). If the
machine is operated with the track width set to a
dimension other than 1280 mm or 970 mm, the
track width will not be secured so that the machine
upper structure will move unstably.
• Never attempt to adjust the track width on a slope.
Failure to follow these instructions will cause the
machine to turn over or skid, possibly resulting in
personal injury.
IMPORTANT: • Check the sliding surfaces on the track
frame for any accumulated debris. If
any debris such as soil has accumulated,
remove the accumulated debris and clean
the surfaces.
• Check the ground surface under the
machine. In case the surface is not flat
or if any protruding obstructions exist,
move the machine to a flat surface area or
remove the obstruction before adjusting
the track width.
• Do not use the track width control function
to move or tow any objects.
Machine failure or damage may result.
Blade (When the track-width control switch is OFF:)
Use lever (1) to raise and lower the blade.
When the lever is released, it automatically returns to its
neutral position, keeping the blade in its position until the
lever is operated again.
(2) Blade raise
(3) Blade lower
Track width (When the track-width control switch is ON:)
Use lever (1) to change the width of the track (under
carriage).
When the lever is released, it automatically returns to its
neutral position, keeping the width in its position until the
lever is operated again.
(2) Narrow width
(3) Extend width
5-6
3
2
3
1
3
2
Track-width control switch
1
ZX18-3(Cab)
ZX18-3(Canopy)
2
3
2
Track-width
control switch
M1NC-05-014
SS4706712
M1NC-04-003
M1NC-04-001
M1NC-05-015