WARNING - Flannery Plant Hire

C. Transmission
1
Travel Reduction Gear
d WARNING:
• Each component of the travel reduction gear
may be hot immediately after operation. Allow
components to cool before starting to work on
them.
MAINTENANCE
• The travel reduction gear may be pressurized.
Be sure to release the internal pressure by slowly
loosen the air bleed plug two to three turns before
removing the plug. Failure to do so may cause the
plug and/or gear oil to fly out, possibly resulting in
personal injury. Keep body and face away from the
air bleed plug.
Check Oil Level --- every 250 hours
1. Park the machine on a level surface.
2. Rotate the travel motor until plugs are positioned as
illustrated on the right. Stop the engine.
3. Slowly loosen plug (1) to release pressure.
4. Remove plugs (1 and 2). Check that oil flows out of the
thread hole for plug (2). If no oil flows out, add oil until
oil flows out of the plughole.
5. After cleaning plugs (1 and 2), and install the plugs (1
and 2).
Tightening torque: 35 ± 5 N·m
(3.5 ± 0.5 kgf·m, 25.3 ± 3.6 lbf·ft)
7-24
1
2
M577-07-013
1
2
M577-07-012