WARNING - Flannery Plant Hire

5
d
Swing Internal Gear
--- every 500 hours
MAINTENANCE
WARNING: Before lubricating the swing bearing,
lower the bucket and the blade to the ground, stop
the engine, and place the pilot control shut-off lever
to the LOCK position. Lubrication and rotation of the
upperstructure must be done by one person only. Be
sure to check that no personnel are present around
the machine before starting to work.
1. Remove the cover from the bottom center of the
undercarriage.
Check if grease inside is cloudy due to mixing of water or
dirt.
2. Apply grease via grease fittings by the quantity shown in
the table.
3. In order to apply grease evenly to the swing gear,
raise the bucket approximately 200 mm (8 in) above
the ground. While swinging the upperstructure at
approximately 90° intervals until one full turn is made,
add grease at each interval.
ZX14-3,
16-3, 18-3
Greasing Quantity Total Grease Capacity
0.2 L (0.21 US qt) 0.6 L (0.63 US qt)
ZX27-3 0.2 L (0.21 US qt)
6
Control Lever Universal Joint
--- every 500 hours or yearly
3.0 to 3.3 L (3.2 to 3.5
US qt)
Pull up the rubber boots under the right and left control levers,
remove two screws (1) to remove bracket (2). After moving the
rubber boots upward, add grease to the four places of the pilot
valve pushers as indicated by arrows.
7-20
Swing Gear Swing Bearing
1
Swing Bearing
ZX14-3, 16-3, 18-3
Swing Gear
ZX27-3
2
M1NC-00-001
M1M7-07-025
M1M7-07-026
M1M7-07-016