WARNING - Flannery Plant Hire

4
d
Swing Bearing
--- every 250 hours
MAINTENANCE
WARNING: Before lubricating the swing bearing,
lower the bucket and the blade to the ground, stop
the engine, and place the pilot control shut-off lever
to the LOCK position. Lubrication and rotation of the
upperstructure must be done by one person only. Be
sure to check that no personnel are present around
the machine before starting to work.
Grease via grease fittings
1. Lower the bucket and the blade to the ground, stop the
engine, and place the pilot control shut-off lever to the
LOCK position. Add grease with a grease gun by two to
three strokes. Lower the bucket and blade to the ground.
2. Raise the bucket approx. 200 mm (8 in) above the
ground. While rotating the upperstructure, add grease
in 8 places at approximately every 90° interval until the
upperstructure has made two turns.
7-19
Swing Gear Swing Bearing
Swing Bearing
ZX14-3, 16-3, 18-3
Swing Gear
ZX27-3
M1NC-00-001
M1M7-07-025