WARNING - Flannery Plant Hire

6
d
Replace Pilot Filter
--- every 1000 hours
MAINTENANCE
WARNING: Be sure to work only after oil temperature
is low or before operation. Failure to do so may
allow high temperature oil to spray, possibly causing
severe burns.
1. Park the machine on a solid level surface. Position the
machine with the arm cylinder fully retracted and the
bucket cylinder fully extended. Lower the bucket and
blade to the ground. Stop the engine.
2. Before replacing the element, be sure to loosen the
hydraulic oil tank cap to release the air pressure from the
hydraulic oil tank.
3. Remove bolts (3) to remove under cover (2) from the rear
left bottom side of the base machine.
Wrench size : 17 mm
Tightening torque : 50 N·m (5 kgf·m, 36 lbt·ft)
7-35
1
1
ZX14-3, 16-3, 18-3
ZX27-3
2
3
M1M7-05-024
M1NC-00-010
M1NC-05-011
M1NC-07-009