WARNING - Flannery Plant Hire

I. Miscellaneous
1
Check Bucket Teeth for Looseness and/or Wear
--- daily
Check the bucket teeth for wear and looseness
MAINTENANCE
Replace teeth (1) if tooth wear exceeds the service limit shown
below.
Dimension A in mm (in.)
New Limit of Use
128 (5.0″) 65 (2.6″)
d
WARNING: Guard against injury from flying pieces
of metal. Use safety equipment such as a helmet and
safety glasses.
1. Use hammer (2) and drift (3) to drive out locking pin
(5). Be careful not to damage rubber pin lock (4) while
removing locking pin (5).
2. Inspect locking pin (5) and rubber pin lock (4) for any
damage, replace if necessary. Short locking pins (5) and
damaged rubber pin locks (4) must be replaced with
new ones.
7-64
RIGHT
4
1 4 5
A
WRONG
Level the bottom surfaces.
Lock pin length is too short.
WRONG WRONG
Steel balls almost come
off due to damage to
the lock rubber.
M104-07-056
2
3
M589-07-017
5
M104-07-118
M104-07-058
Steel balls can be
depressed by finger force.
M104-07-059