WARNING - Flannery Plant Hire

Unloading
d WARNING:
• Always travel the machine slowly.
• Press the travel mode switch toward the TURTLE
side.
TRANSPORTING
• Steering on a ramp may create a danger of tipping
over. Never attempt to change travel direction on
a ramp, possibly causing the machine to become
unstable. If steering is unavoidable, first move
back to the ground, modify traveling direction,
and begin to drive again.
• The top end of the ramp where it meets the
flatbed, there is a sudden bump. Slowly drive over
it.
• Use extra care when rotating the upperstructure
on the flatbed to prevent possible injury from
machine tipping. Slowly rotate the upperstructure
with the arm fully rolled in under the boom to
maintain the good machine stability.
IMPORTANT: During unloading operation, maintain the
angle between the boom and the arm at
90 to 110°. If the machine is unloaded with
the arm fully rolled in, damage to the base
machine may result.
1. Before moving the machine from the flatbed rear end
to the ramp, position the front attachment so that the
angle between the boom and the arm becomes into
the range of 90 to 110°. While allowing the bucket to be
contacted on the ground, slowly move the machine.
IMPORTANT: When moving the machine over the end
of the flatbed onto the ramp, take care not
to allow the bucket to come into contact
with the ground. Damage to the hydraulic
cylinders may result.
2. Do not lift the bucket off the ground until the machine is
completely moved onto the ramp.
3. Slowly move the machine forward while raising the
boom and arm gradually until the machine is completely
off the ramp.
6-4