The Virtualization Cookbook for SLES 10 SP2 - z/VM - IBM

==> Press Enter at the VM READ prompt
► Run the instvm dvd command:
==> instvm dvd
...
HCPPLD8329I POSTLOAD EXEC ENDED SUCCESSFULLY
...
HCPIVM8392I INSTVM ENDED SUCCESSFULLY
This EXEC continues the installation process. This step should take about 4-8 minutes.
The last message should be HCPIVM8392I INSTVM ENDED SUCCESSFULLY
► Load the recommended service. First IPL CMS then press Enter at the VM READ prompt:
==> ipl cms
==> Press Enter at the VM READ prompt
Ready;
► For z/VM 6.1, the service name is 6101RSU1. Verify this file exists on the MAINT 500 disk:
==> acc 500 c
DMSACC724I 500 replaces C (2CC)
==> listfile * * c
6101RSU1 SERVLINK C1
► Run the SERVICE ALL command to apply the service:
==> service all 6101rsu1
...
This step should take about 3-6 minutes. The last message should be:
40 The Virtualization Cookbook for RHEL 6
VMFSRV2760I SERVICE processing completed successfully.
► IPL CMS and run the put2prod command. This puts the service into production:
==> ipl cms
==> Press Enter
Ready;
==> put2prod
This step should take about 2-4 minutes. The last message should be:
VMFP2P2760I PUT2PROD processing completed successfully.
A return code of 0 is ideal. You may get a return code of 4 and the message:
VMFP2P2760I PUT2PROD process completed with warnings.
In general on z/VM, a return code of 4 is acceptable. That means that only warnings were
issued. A return code of 8 or greater generally means that errors were encountered.
► Enter the following command to shutdown and re-IPL your system:
==> shutdown reipl
SYSTEM SHUTDOWN STARTED
► You will lose the current session on the Integrated 3270 Console, but the system should
come back in about 2-4 minutes.
► After it comes back, the last message should be “Press enter or clear key to
continue”. Press Enter and you should see a z/VM logon screen.
Congratulations! You should now have a vanilla z/VM system installed.