The Virtualization Cookbook for SLES 10 SP2 - z/VM - IBM

==> rename profile tcpip d poksnd61 = =
► You have now backed up and renamed your TCP/IP profile. You can verify using the
LISTFILE command:
==> listfile * * d
POKSND61 TCPIP D1
PROFILE $TCPBAK D1
SYSTEM $DTCBAK D1
SYSTEM DTCPARMS D1
TCPIORIG PROFILE D1
4.5.2 Copy the PROFILE XEDIT file
Again copy the PROFILE XEDIT from the MAINT 191 disk so XEDIT sessions will have a
common interface among user IDs.
► Use the VMLINK command to both link to the disk read-only and to access it as the highest
available file mode. The default read password is read:
==> vmlink maint 191
ENTER READ PASSWORD:
read
DMSVML2060I MAINT 191 linked as 0120 file mode Z
► Copy the PROFILE XEDIT to your A disk:
==> copy profile xedit z = = a
Now, XEDIT sessions on TCPMAINT will have the same configuration as on MAINT.
4.5.3 Configuring the FTP server
Turn on the FTP server by editing the renamed configuration file:
► Edit the file
==> x poksnd61 tcpip d
► Add an AUTOLOG statement near the top of the file with FTPSERVE as the only entry.
► In the PORT statement, remove the semicolons to uncomment the lines with FTPSERVE on
them (ports 20 and 21). These changes will cause the FTP server to start when TCPIP is
started. The important lines before the file is edited and after are shown:
==> x poksnd61 tcpip d
Before:
; ----------------------------------------------------------------------
OBEY
OPERATOR TCPMAINT MAINT MPROUTE DHCPD REXECD SNMPD SNMPQE LDAPSRV
ENDOBEY
; ----------------------------------------------------------------------
PORT
; 20 TCP FTPSERVE NOAUTOLOG ; FTP Server
; 21 TCP FTPSERVE ; FTP Server
23 TCP INTCLIEN ; TELNET Server
; 25 TCP SMTP ; SMTP Server
...
After:
; ----------------------------------------------------------------------
OBEY
48 The Virtualization Cookbook for RHEL 6