The Virtualization Cookbook for SLES 10 SP2 - z/VM - IBM

Pay attention to the output. If you get any syntax errors, fix them before proceeding.
► Release and detach the MAINT CF1 disk with the RELEASE command. Then put it back online
with the CPACCESS command:
==> rel f (det
DASD 0CF1 DETACHED
==> cpacc * cf1 a
CPACCESS request for mode A scheduled.
HCPZAC6732I CPACCESS request for MAINT's 0CF1 in mode A completed.
► Verify that the CP disk A has been accessed using the QUERY CPDISK command:
==> q cpdisk
Label Userid Vdev Mode Stat Vol-ID Rdev Type StartLoc EndLoc
MNTCF1 MAINT 0CF1 A R/O 610RES 6280 CKD 39 158
MNTCF2 MAINT 0CF2 B R/O 610RES 6280 CKD 159 278
MNTCF3 MAINT 0CF3 C R/O 610RES 6280 CKD 279 398
Note that all three CP disks are now accessed.
4.5 Configuring TCP/IP to start at IPL time
Configure the TCPIP service machine to be started when z/VM IPLs. This is commonly
accomplished from AUTOLOG1’s PROFILE EXEC. If the noautolog parameter is not specified
when z/VM is IPLed, the AUTOLOG1 virtual machine is started. Because this virtual machine
IPLs CMS, the PROFILE EXEC that is found on its A disk is run. This is analogous to the
/etc/profile file on Linux and the autoexec.bat on DOS systems.
► Logoff of MAINT.
==> log
► You should see a new logon panel. Logon to AUTOLOG1. Again the password is the same
as the user ID.
► At the VM READ prompt enter the command ACCESS (NOPROF so that the PROFILE EXEC is not
run.
z/VM Version 6 Release 1.0, Service Level 0901 (64-bit),
built on IBM Virtualization Technology
There is no logmsg data
FILES: NO RDR, NO PRT, NO PUN
LOGON AT 09:29:16 EST FRIDAY 11/20/09
DMSIND2015W Unable to access the Y-disk. Filemode Y (19E) not accessed
z/VM V6.1.0 2009-11-19 13:47
==> acc (noprof
► Copy the PROFILE XEDIT from the MAINT 191 disk so XEDIT sessions will have a common
interface among user IDs.
a. Use the VMLINK command to both link to the disk read-only and to access it as the
highest available file mode. The default read password is read:
==> vmlink maint 191
ENTER READ PASSWORD:
==> read
DMSVML2060I MAINT 191 linked as 0120 file mode Z
b. Copy the PROFILE XEDIT to your A disk:
==> copy profile xedit z = = a
► Make a backup copy of the PROFILE EXEC and edit it:
46 The Virtualization Cookbook for RHEL 6