Operating Instructions, complete - W. Gantenbein GmbH

More documents

Recommendations

Info

Operating Instructions BUFALO Rondofix V3.0 6. Commissioning 6.1. Introduction Brief description: This section provides information for successfully installing and commissioning. It deals with the erection, assembly and the first commissioning of the BUFALO RONDOFIX. It is the operator's responsibility that everyone involved in the installation of the BUFALO RONDOFIX has read and understood these operating instructions. The following personnel and technical qualifications are required for erecting, assembling and commissioning the machine. 6.1.1. Personnel, qualification The work described in this section may be carried out only by authorized skilled personnel who have had appropriate technical training and can draw upon the necessary experience, or who have been suitably instructed by the operator. 6.1.2. Technical documentation This equipment may pose dangers if the safety rules are not followed. See Section 3: Security. The following technical documentation is needed for erecting, assembling and commissioning the machine: • electrical diagram This may be found in your technical documentation. 6.1.3. Technical documentation The following technical documentation is needed for erecting, assembling and commissioning the machine: • electrical diagram This may be found in your technical documentation. � 38 Operatings Instructions Edition 22. November 2007 Bufalo Rondofix V3.0
Operating Instructions BUFALO Rondofix V3.0 6.2. Erecting and testing the machine Check the following points before commissioning: • Is the power cable intact and properly connected? Indication Check the rotation of the motors. The gluing rollers may be used for this. If they will not turn, the motor rotation needs reversing. • Has the power cable been laid covered and secured? • Are there no foreign materials on or at the machine'? • Check whether the paper grippers run properly and unobstructed. • Check whether the infeed station functions faultlessly and unobstructed. • Check whether the cutting station functions faultlessly and unobstructed. • Check whether the fixing station functions faultlessly and unobstructed. • Check whether the gluing station and gluing rollers function faultlessly and unobstructed. • Check whether the pressing station functions faultlessly and unobstructed. • Check whether the delivery station functions faultlessly and unobstructed. • If one of the stations malfunctions, see Section 7.6 Trouble Shooting and rectify the fault as instructed therein. 6.2.1. Putting the machine into operation To commission the machine proceed as follows: • Schalten Sie den Hauptschalter ein. • Check the emergency stop switches and release them if necessary (see subsection 3.4). • Switch the machine on (see Section 5). • Switch the machine over to manual operation (see Section 7). • Test the door interlock circuit of the cutter/fixer and gluing station/press by opening the doors singly and closing them again. When any of these doors is opened the control must cut out and a fault must be signalled. 6.2.2. Testing the function Check all functions according to Section 5 before considering the commissioning completed and handing the machine over for normal operation. 6.2.3. Acceptance certificate The acceptance certificate must be copied. Do not write on the original. See appendix. � 39 Operatings Instructions Edition 22. November 2007 Bufalo Rondofix V3.0
Page 1 and 2: Operating Instructions BUFALO Rondo
Page 37: Operating Instructions BUFALO Rondo
Page 87: Operating Instructions BUFALO Rondo

Operating Instructions, complete - W. Gantenbein GmbH

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?