Operating Instructions, complete - W. Gantenbein GmbH
Operating Instructions, complete - W. Gantenbein GmbH
Operating Instructions, complete - W. Gantenbein GmbH
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Operating</strong> <strong>Instructions</strong><br />
BUFALO Rondofix V3.0<br />
7.6.3. Programme Number<br />
The following is displayed:<br />
Causes:<br />
Program/-Number<br />
• A programme number outside the limits has been entered. The highest programme<br />
number is 20. Refer to Programme Input.<br />
Correction:<br />
• This error message must first be exited by pressing the "Enter" key on the terminal,<br />
and the correct programme number entered.<br />
7.6.4. Hydraulics and Motors<br />
The following is displayed:<br />
Causes:<br />
Hydraulic & Motors<br />
• The hydraulic oil is too hot, or the drive motor for the hydraulic pump is overloaded.<br />
• A motor or overload protection of the other drives or glue heater has switched off.<br />
Correction:<br />
• Switch on the non-active monitoring or drive component.<br />
Exit:<br />
• Press the "Enter" key on the terminal.<br />
7.6.5. Advance Front<br />
The following is displayed:<br />
Causes:<br />
Advance Front<br />
• The feed advance cylinder has not reached the front limit switch (right) in<br />
automatic mode. The timeout has expired. Possibly the end limit switch is set<br />
incorrectly or is defect.<br />
Correction:<br />
• This error message must first be exited by pressing the "Enter" key on the terminal.<br />
Then switch the machine to manual operational mode. Advance the cylinder<br />
forwards. Correct or exchange end limit switch.<br />
� 58 <strong>Operating</strong>s <strong>Instructions</strong> Edition 22. November 2007<br />
Bufalo Rondofix V3.0