2000 Hook-up Book - Spirax Sarco
2000 Hook-up Book - Spirax Sarco
2000 Hook-up Book - Spirax Sarco
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Figure II-55<br />
Draining and Air Venting<br />
Flatwork Ironer<br />
Gravity<br />
Return<br />
Steam Main<br />
Sight<br />
Glass with<br />
Check Valve<br />
Float &<br />
Thermostatic<br />
Steam Trap<br />
Strainer<br />
Strainer<br />
Figure II-56<br />
System Units for Condensate Removal<br />
and Air Venting of Rotating Cylinders<br />
(for surface speeds below 800 FPM)<br />
The <strong>Spirax</strong> <strong>Sarco</strong> units (Strainers,<br />
Float & Thermostatic Steam Traps with<br />
SLR feature, Sight Glass, Air Reservoir<br />
with Air Vent) provides for the best<br />
drainage of condensate and noncondensibles<br />
from rotating cylinders.<br />
Drain to<br />
Safe Place<br />
Balanced<br />
Pressure<br />
Thermostatic<br />
Air Vent<br />
Air<br />
Reservoir<br />
Sight<br />
Glass<br />
Steam Beds<br />
Float &<br />
Thermostatic<br />
Steam Trap<br />
with SLR<br />
feature<br />
Balanced<br />
Pressure<br />
Thermostatic<br />
Air Vent<br />
The steam traps are often located at<br />
one end for ease of maintenance,<br />
with long pipes connecting them to<br />
the drainage points. If steam-locking<br />
is a problem in these long pipes,<br />
then a Float / Thermostatic steam<br />
trap with a steam-lock release is the<br />
best selection. The beds should be<br />
air vented at points remote from the<br />
steam entry. Steam s<strong>up</strong>ply lines to<br />
ironers should be drained, ideally<br />
using a separator.<br />
Rotating<br />
Cylinder<br />
Drain to<br />
Safe Place<br />
Gravity<br />
Condensate<br />
Return<br />
HOOK-UP DIAGRAMS<br />
111