Urma Digiset 5 USERMANUAL - Urma AG

digiset 5
7.1.2.2 Delete tool references
After selecting the "Delete" operating mode the corresponding tool reference must be
selected in the selection window.
There is an additional security query before the tool reference can be deleted after it
is confirmed.
The 0 tool reference cannot be deleted.
7.1.2.3 Change tool references
After selecting the "Change" operating mode the corresponding tool reference must
be selected once more in the selection window.
After confirming that you have found the correct tool reference, a window in which
changes can be made opens as it does when entering a new tool reference.
7.1.2.4 Show tool reference list
After selecting the "Show list" operating mode, a window opens with a selection list of
the saved tool references and the buttons explained below:
Select The tool reference highlighted in the selection list will be loaded.
Change The tool reference highlighted in the selection list can be
changed.
Delete The tool reference highlighted in the selection list is deleted
after it has been confirmed with the security query.
Print list The tool references will be printed giving the tool reference
number and the tool reference name in table form using the
interface defined in the "Output format / Measured value"
menu item.
Close The tool reference list is closed.
The 0 tool reference cannot be edited and will therefore not be
displayed in the tool reference list.
Urma AG, Switzerland www.urma.ch page 35