Urma Digiset 5 USERMANUAL - Urma AG
Urma Digiset 5 USERMANUAL - Urma AG
Urma Digiset 5 USERMANUAL - Urma AG
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
digiset 5<br />
8.2.3 Preset<br />
The measuring lines are created on the contour of the object to be measured. Both<br />
adjustment bars are hidden. The offset of the measuring lines and the fixed cross<br />
hairs in the X and Z direction is taken into account with the current position.<br />
You access this operating mode using the following menu steps:<br />
Main menu Sub-menu 1<br />
Imaging � Preset<br />
After selection the system analyses the object contour and automatically suggests a<br />
measuring procedure for carrying out the measurements immediately. The measuring<br />
procedure used is displayed in the status window at the same time. If an alternative<br />
measuring method is required it is possible to enter the measuring procedure manually<br />
by pressing the button.<br />
Procedure:<br />
�<br />
1. Move the object into the camera’s visual range.<br />
2. If the relevant contour of the object is not clear, select the "Range" operating<br />
mode and, using the mouse, make it the required size and drag it round the<br />
relevant edge.<br />
3. Select the operating mode as described above.<br />
4. <strong>Digiset</strong> 5 automatically determines the best measuring procedure and the<br />
test LED goes green. Depending on the measuring procedure selected<br />
measuring lines are created on the object’s contour.<br />
5. The object to be measured can now be set to the required size taking note<br />
of the reading.<br />
6. If the TCAM2 does not set the measuring procedure to your requirements,<br />
change this manually.<br />
The object to be measured must be in the camera’s focussing<br />
area.<br />
<strong>Urma</strong> <strong>AG</strong>, Switzerland www.urma.ch page 44
Change language