Urma Digiset 5 USERMANUAL - Urma AG
Urma Digiset 5 USERMANUAL - Urma AG
Urma Digiset 5 USERMANUAL - Urma AG
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
digiset 5<br />
8.2.4 Measure centre<br />
Here the TCAM2 determines the edge pixel next to the cross hair origin point. This is<br />
done using the pointers in the adjustment bars that should, ideally, both be in the<br />
middle. The edge point is next to the cross hair origin point when both pointers are in<br />
the middle of the green area.<br />
You access this operating mode using the following menu steps:<br />
Main menu Sub-menu 1<br />
Imaging � Measure centre<br />
Selecting this measuring method is recommended when carrying out the following<br />
setup settings because any dust and dirt residue on the object to be measured, e.g.<br />
gauge (calibrating mandrel or ball gauge), will not affect the measuring results.<br />
• Parallel correction<br />
• Absolute zero point<br />
<strong>Urma</strong> <strong>AG</strong>, Switzerland www.urma.ch page 45