kd-r618 / kd-a615 / kd-r610 instructions - Sonic Electronix

USB device playback
Bluetooth * 2
Symptom Remedy/Cause
Tracks/folders are not played
back in the order you have
intended.
• “CANNOT PLAY” flashes on
the display.
• “NO USB” appears on the
display.
• The unit cannot detect the
USB device.
While playing a track, sound is
sometimes interrupted.
Correct characters are not
displayed (e.g. album name).
Bluetooth device does not
detect the unit.
The unit does not detect the
Bluetooth device.
The unit does not make pairing
with the Bluetooth device.
The playback order is determined by the write-in time
stamp. The first track/folder written into the USB device
will be the first track/folder for playback.
• Attach a USB device that contains tracks encoded in
an appropriate format.
• Reattach the USB device again.
The MP3/WMA tracks have not been properly copied
into the USB device.
Copy MP3/WMA tracks again into the USB device, and
try again.
This unit can only display letters (upper case),
numbers, and a limited number of symbols.
The unit can be connected with one Bluetooth mobile
phone and one Bluetooth audio device at a time.
While connecting a device, this unit cannot be detected
from another device. Disconnect currently connected
device and search again.
• Check the Bluetooth setting of the device.
• Search from the Bluetooth device. After the device
detects the unit, select “OPEN” on the unit to connect
the device. ( 13)
• Enter the same PIN code for both the unit and target
device.
• Select the device name from “SPECIAL,” then try to
connect again. ( 13)
• Try to pair/connect from the Bluetooth device.
Echo or noise occurs. Adjust the microphone unit position.
Phone sound quality is poor. • Reduce the distance between the unit and the
Bluetooth mobile phone.
• Move the car to a place where you can get a better
signal reception.
* 2 For Bluetooth operations, refer also to the instructions supplied with the Bluetooth Adapter.
ENGLISH
37