PowerFlex 755 Install Manual.pdf
PowerFlex 755 Install Manual.pdf
PowerFlex 755 Install Manual.pdf
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Auxiliary Power Supply Option Module<br />
Table 53 TB1 Terminal Designations<br />
20-750-APS Terminal Name Description<br />
AP+<br />
AP–<br />
AP+ +24 Volt Auxiliary Power Connections for customer supplied 24V/3A<br />
power supply.<br />
Sh<br />
AP– Auxiliary Power Common<br />
AP+<br />
AP-<br />
Sh<br />
Sh Shield Terminating point for wire shields when an<br />
EMC plate or conduit box is not installed.<br />
Important: The Auxiliary Power Supply option module may be installed in<br />
any option port. Due to its size, the module will extend over and<br />
block an adjacent port. Therefore, installation in Port 8 is<br />
recommended.<br />
A connector cable is provided with Auxiliary Power Supply option modules<br />
for use in <strong>PowerFlex</strong> 753 drives. The cable is used to connect the module to<br />
the backplane when installed on the upper control pod brackets. The<br />
connector cable is not used with <strong>PowerFlex</strong> <strong>755</strong> drives.<br />
Figure 35 Auxiliary Power Supply <strong>Install</strong>ation in 753 Drives<br />
<strong>PowerFlex</strong> 750-Series <strong>Install</strong>ation Instructions – Publication 750-IN001C-EN-P – September 2009<br />
85
Change language