DM-4800 OWNER'S MANUAL - zZounds.com - Tascam

8 – Remote operation : Selecting devices for transport control
When the scan is complete, a pop-up screen appears,
showing the detected devices and their assignments
to the control maps.
Any selected devices that may be controlled are
detected and a new map is created for each such
device.
To use a transport mapping
Of course, at least one transport mapping must exist
before this operation can be carried out.
1 Press and hold down the MACHINE SEL (F7)
key.
2 Press the numeric key corresponding to the
map you want to use (0 through 9).
Viewing the transport mappings
To view the transport mappings (that is, the list of the
devices that will be controlled in each mapping):
Editing a mapping
When a mapping has been made, parameters other
than the transport control may be edited (for
instance, the use of the REC keys).
To make these changes a permanent part of the currently-loaded
map:
108 TASCAM DM-4800 User’s Manual
A message is shown if there are more devices connected
than can be added to the list (that is, more
than 10).
If there are IDs associated with the devices, these are
also shown.
The DM-4800’s transport control keys will now control
the device selected in that map and the other
mapping features will also be enabled. A popup
shows the currently-recalled memory (or a message
if no mapping has been recalled).
The MAP field at the lower part of the screen shows
the currently-loaded map.
1 Press and hold SHIFT and press the LOCATE
LIST (F8) key. The device controlled in each
map, together with its ID, is shown.
2 Press the ENTER key to continue operations.
1 Move the cursor to the number by the MAP
field.
2 Use the wheel to select the mapping memory
into which the current mapping will be stored.
Press ENTER.
3 Press ENTER (the on-screen STORE button).