Level 6 Graduate Diploma in Engineering (9210-01) - City & Guilds

Unit 135 Mechanics of solids
Level: 6
Introduction
This unit is about the elastic behaviour of engineering components and the use of theoretical,
numerical and experimental techniques to determine stresses, strain and deflections under various
load conditions.
Unit aim
The aim of this unit is to provide knowledge and understanding of elastic behaviour and an
introduction to non elastic behaviour of engineering components using classical theory,
approximate numerical methods and experimental techniques.
Learning outcomes
There are three learning outcomes to this unit. The learner will:
1. Calculate stresses, strain and deflections in a range of components under various load
conditions
2. Select appropriate methods for the detail design of components
3. Demonstrate an understanding of the basis of computer software used in stress analysis
Guided learning hours
It is recommended that 150 hours should be allocated for this unit of which 90 would be direct
taught hours while the remainder and for laboratory practical work and independent study. The unit
may be carried out on a full time or part time basis.
Assessment
This unit will be assessed by means of one three hour examination paper plus satisfactory
completion of prescribed assignments and laboratory work. The assessments will be carried out
separately.
Learners are expected to have knowledge of mathematics and scientific principles needed to solve
problems applicable to mechanical engineering as per the City & Guilds Advanced Technician
Diploma 2565-03-047 or relevant HND or other equivalent.
Level 6 Graduate Diploma in Engineering (9210-01) 169