Level 6 Graduate Diploma in Engineering (9210-01) - City & Guilds

Unit 111 Structural analysis
Level: 6
Introduction
This unit is intended to extend the knowledge gained in unit 9201-01-102 by analysing more
complicated engineering components and to determine stresses, strain and deflections under more
varied load conditions.
Unit aim
The aim of this unit is to develop further knowledge on elastic and plastic analysis and design of
more complex structures. On the successful completion of this unit the learner should have
sufficient knowledge and skills to analyse and design structures in a civil engineering design office.
Learning outcomes
There are three learning outcomes to this unit. The learner will:
1. Perform elastic and plastic analysis of structures
2. Explain basics of design, define loads and design steel structures
3. Demonstrate the use of computer software in stress analysis and design of structural members
Guided learning hours
It is recommended that 150 hours should be allocated for this unit of which 60 would be direct
taught hours and the remainder for design work and independent study. The unit may be carried
out on a full time or part time basis.
Assessment
This unit will be assessed by means of one three hour written examination plus satisfactory
completion of the prescribed practical and laboratory work. The assessments will be carried out
separately.
Learners are expected to possess knowledge of the mathematics required for calculations by
holding a relevant City & Guilds Advanced Technician Diploma or relevant HND or other equivalent.
Level 6 Graduate Diploma in Engineering (9210-01) 65