Series 360, Granville-Phillips, Stabil-Ion, Ionization, Vacuum ...

4 Preparing the Stabil-Ion System for Operation
360118
MEMORY MODULE
S/N 3456 CA
RS-232
ELECTROMETER
CONVECTRON
IG-1 AUTO
PROCESS CONTROL
Off SP On
Data Port
IG2 Scale
IG1
Factor
Adjust
Pressure
Range
L HL H
Cathode
1 21 2
IG1 IG2
OFF SET
ATM
VAC
IG-2 AUTO
OFF SET
ATM
VAC
1
2
3
4
5
6
3
▲
Set
▲
C
H
A
N
N
E
L
IG1
O
Degas
O
IG2
O
On
O
Remote
Figure 4-17
Control Unit Front Panel (with Door Open) Showing Memory Module Location.
5. Turn on power. Within 5 seconds the data in the Memory Module will transfer to main
memory.
6. The last 3 digits of the Memory Module identification numbers will be displayed on lines A
and/or B of the display depending on which gauge has been calibrated. See Figure 4-18. The
numbers will appear for a few seconds and thereafter for a few seconds each time the Stabil-
Ion System power is turned on. If the memory contains standard factory supplied data, the
serial number of that data, when displayed, will begin with 0.
7. Turn off power, and using antistatic
protection, unplug the Memory
Module and return it to its antistatic
packaging.
8. Save the Memory Module together
with the original calibration data, all
properly identified, for possible later
use.
IG
A
B
456
1
2
3
4
5
6
IG1
O
O
IG2
O
DEGAS ON
O
Figure 4-18
Control Unit Front Panel Display Showing Memory
Module Identification Numbers Displayed.
4-22
Series 360 Stabil-Ion December, 2001