Using JMP - SAS

Chapter 4 Enter and Edit Data 109
Select Columns
Figure 4.5 Points Selected
Select Columns
To select one entire column:
• In the data grid, click in the empty space around the column name.
or
• In the Columns panel, click the column name.
To select a specific column number:
1. Select Cols > Go to.
2. Enter the column number or name and click OK.
To select multiple columns:
• For continuous selection:
– Click and drag the cursor over the column name.
– Hold down the SHIFT key and click the first and last columns of the desired range.
– Hold down the SHIFT key and press the left or right arrow key.
• For discontiguous selection:
– Hold down the CTRL key and click on each column.
To select or deselect all columns:
• Hold down the SHIFT key and click the upper triangular area in the upper left corner of the data grid to
select. Click again in the same area to deselect all columns. See Figure 4.6.