GR-DVL9600 GR-DVL9500 - JVC

1
CONFIRM POWER-OFF STATUS
Make sure the camcorder’s power is off.
2
CONNECT CAMCORDER TO TV OR
VCR
Pull out the connector cover and open it.
Connect as shown in the illustration ( pg. 48).
If Using A VCR . . . go to step 3.
If not . . . go to step 4.
3
CONNECT VCR OUTPUT TO TV
INPUT
Refer to your VCR’s instruction manual.
4
SUPPLY POWER
Turn on the camcorder, the VCR and the TV.
5
SELECT MODE
Set the VCR to its AUX input mode, and set the
TV to its VIDEO mode.
To choose whether or not the following displays
appear on the connected TV . . .
• Date/Time, Time Code
.... set to “ON” or “OFF” in the Playback Menu
( pg. 46).
• Playback Sound Mode Display
.... set the Power Switch to the camera position
(“ ”, “5S” or “ ”) and press MENU. Set
“ON SCREEN” in the Date/Time Menu
( pg. 8) to “ON” or “OFF”. Then set the
Power Switch back to “ ”.
EN49
NOTES:
● It is recommended to use the AC Power Adapter/
Charger as the power supply instead of the battery
pack. ( pg. 7)
● Never connect any other Audio/Video cable than
the provided Audio/Video cable to the camcorder's
AV OUT connector.
● When using the provided cables, make sure you
connect the end of the cable with the core filter to
the camcorder. The core filter reduces interference.
● To monitor the picture and sound from the
camcorder without inserting a tape, set the
camcorder’s Power Switch to the camera position
(“ ”, “ ”, “5S” or “ ”), then set your TV to
the appropriate input mode.
● Make sure you adjust the TV sound volume to its
minimum level to avoid a sudden burst of sound
when the camcorder is turned on.
● If you have a TV or speakers that are not specially
shielded, do not place the speakers adjacent to the
TV as interference will occur in the camcorder
playback picture.
● To keep the camcorder's display from appearing on
the TV screen during playback, press IND. ON/
OFF for longer than 1 second ( pg. 15).
● While the Audio/Video cable is connected to the
AV OUT connector, sound cannot be heard from
the speaker.
● Set the video out select switch of the cable adapter
as required:
Y/C: When connecting to a TV or VCR which
accepts Y/C signals and uses an S-Video cable.
CVBS: When connecting to a TV or VCR which
does not accept Y/C signals and uses an audio/
video cable.