On-Board® W Module Programming and Operation ... - PTB Sales

On-Board W Module Programming and Operation
CTI-CRYOGENICS
HELIX TECHNOLOGY CORPORATION
Section 1 - Common On-Board Module
Information
Introduction
Section 1 describes the following information which is common to all
On-Board Modules: microprocessor control, remote operations, keypad/
display, on-line help, software version verification, and storage.
Microprocessor Control System
The On-Board Waterpump is equipped with a state-of-the-art microprocessor
controlled W Module which allows the user to monitor, program, and
operate a wide range of important vacuum system functions.
The On-Board module communicates with the waterpump through a
keypad/display that is mounted on the waterpump. The user can operate
the keypad/display by merely pushing an easily learned sequence of keys.
Refer to Section 3 - Programming and Operation for a complete description
of programming and operation information of each On-Board W
Module function.
Remote Operation Options
A remote keypad/display, which mounts in a standard 19 inch electronics
rack, is available as an option. The remote keypad/display provides the
same functionality of the waterpump mounted device but can be located in
a different location from the waterpump. Refer to Section 1 - On-Board
Waterpump Description of the On-Board Waterpump Installation and
Service Instructions manual, CTI-CRYOGENICS P/N 8040364 for more
information.
The On-Board module is also capable of being controlled from a personal
or host computer via the RS-232 port on the rear of the module. The
RS-232 port is standard equipment. Refer to Appendix B for more
information. The On-Board module can also be controlled via the On-
Board Network Terminal using the network connectors located on the rear
of the module.
P/N 8040365 1-1