On-Board® W Module Programming and Operation ... - PTB Sales
On-Board® W Module Programming and Operation ... - PTB Sales
On-Board® W Module Programming and Operation ... - PTB Sales
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>On</strong>-Board W <strong>Module</strong> <strong>Programming</strong> <strong>and</strong> <strong>Operation</strong><br />
CTI-CRYOGENICS<br />
HELIX TECHNOLOGY CORPORATION<br />
2. Press 1 or 2 depending upon which relay is being selected. The<br />
selected relay number along with the ON/OFF <strong>and</strong> Auto/Manual<br />
status are displayed.<br />
3. Press the Next key until AUX TC appears in the display.<br />
4. Press the Enter key. The cursor is placed under the current lower<br />
limit (LL) value.<br />
NOTE: If a number which is not in the proper range is entered, LL-???K<br />
or UL-KKK? will be displayed. Press the Clear button to continue.<br />
5. Using the keypad, enter the new lower limit value.<br />
6. Press the Enter key. The cursor is placed under the current upper<br />
limit (UL) value.<br />
7. Using the keypad, enter the new upper limit value.<br />
8. Press the Enter key. The limit values are programmed.<br />
9. Press the MONITOR key. The <strong>On</strong>-Board microprocessor will<br />
monitor system operation.<br />
Cryopump<br />
This procedure programs relay 1 or 2 to activate/deactivate when the<br />
waterpump motor is turned ON or OFF.<br />
1. Press the RELAYS key on the keypad/display.<br />
2. Press 1 or 2 depending upon which relay is being selected. The<br />
selected relay number along with the ON/OFF <strong>and</strong> Auto/Manual<br />
status are displayed.<br />
3. Press the Next key until CRYOPUMP appears in the display.<br />
4. Press the Enter key. FNC=CRYOPUMP will be displayed. The<br />
relay is programmed.<br />
5. Press the MONITOR key. The <strong>On</strong>-Board microprocessor will<br />
monitor system operation.<br />
REGEN Track<br />
This procedure programs relay 1 or 2 to activate/deactivate when the<br />
waterpump initiates/completes a regeneration cycle.<br />
1. Press the RELAYS key on the keypad/display.<br />
P/N 8040365 3-57
Change language